Abstract:In this paper, signal descriptions and formulations for the radio frequency ( RF) front-end of a passive backscatter radio frequency identification ( RFID) reader working at ultra high frequencies ( UHF) are discussed in detail, and a set of design considerations aiming to improve the read range are outlined. The reader's architecture is proposed and the design details of its RF frond-end are presented. The read range is formulated through calculating the time-averaging power absorbed by the tag and the signal-noise-ratio ( SNR) of the demodulation, and accordingly RFID systems can be classified into tag-determining and reader-determining ones. It is concluded that the gain of the reader antenna, the phase noise of the local oscillation ( LO) and the receive-transmit isolation coefficient dominate the demodulation output noise of the reader, and consequently the reader-determining maximum operational distance. A prototype reader working at the frequency of 915MHz was built with off-the-shelf components and was evaluated with a commercial tag in an indoor environment. The measured results show that this RFID system is of tag-determining and has a read range of 8.4 meters, which are in good agreement with the calculated results.

System Design Considerations Of Highly-Integrated Uhf Rfid Reader Transceiver Rf Front-End

Issues in Integrated Circuit Design for UHF RFID

Design for the reader of UHF Radio frequency identification

A System Design for the Reader of Microwave Radio Frequency Identification

Electromagnetic Environment of Uhf-Rfid

Signal Descriptions and Formulations for Long Range Uhf Rfid Readers

Design of rf front end for cavity beam position monitor based on ics *

Design Consideration of an Multimode, Power-Controllable Transmitter for UHF Mobile RFID Reader

Design and Analysis of Analog Front-End of Passive RFID Transponders

Analysis And Design Of A Fully Integrated Soc For Uhf Rfid Reader In Cmos Technology

Design and Implementation of a High Sensitivity Fully Integrated Passive UHF RFID Tag

A Fully Integrated CMOS Transceiver for Mobile UHF RFID Reader

A Fully Integrated CMOS UHF RFID Reader Transceiver for Handheld Applications

Channel arrangement in multi-reader RFID system

A Low-Power RF Front-End of Passive UHF RFID Transponders

Design and implantation of high frequency radio frequency identification reader virtual instrumentation system

Design and implementation of baseband transmitter for UHF RFID reader

Design of an UHF RFID Interrogator

An On-Chip Configurable Receiver with >55-Db Tx Leakage Suppression for UHF RFID Reader

A 90nm CMOS UHF/UWB Asymmetric Transceiver for RFID Readers

A Low Power Low Cost Fully Integrated Uhf Rfid Reader With 17.6dbm Output P1db In 0.18 Mu M Cmos Process