Characterization of Organic Light-emitting Devices Based on NPB Doped in Poly(N-vinylcarbazole) Matrix
Tao MA,Jun-sheng YU,Lu LI,Wen WEN,Xiao-qing TANG,Ya-dong JIANG
2008-01-01
Chinese Journal of Luminescence
Abstract:Organic light emitting diodes (OLEDs) have been extensively investigated and significantly improved over the past two decades. The mechanism for electroluminescent (EL) phenomenon involves in the injection of holes from anode and electrons from cathode under forward bias voltage, then the hole-electron forming the exciton, and light emission through the radiative recombination of excitons. Due to the superior achieved performance, OLEDs are potential candidate not only for next generation displays, but also for solid state lighting application which requires high efficiency and low operating voltage. Through proper material design/choice and device fabrication, various colors of bright luminance have been developed for use in single- or full-color application. Among various colors, white organic light-emitting diodes (WOLEDs) draw particu- lar attention as their highly potential application in blacking, full color application, as well as in lighting pur- poses. So far, a variety of methods have been proposed to achieve a WOLED, such as (I) a multilayer device with blue, green, and red emissive layers, a doped device with a host material and blue, green, and red fluorescence dyes, (III) a single-emission-layer device with white emission material, (IV) excimer and exciplex emission, and (V) stacked structure. About IV, white-light emission can be obtained from a bilayer device using two blue-emitting polymers, in which an exciplex emission at the bilayer interface occurs in addition to an emission from one of the emitter. In addition, finding a simple fabricating way to realize full-color OLEDs is also an important and imperative approach to reduce manufacturing cost in industrial production. In this work, OLEDs were fabricated with a simple structure of indium-tin-oxide (ITO)/poly(N-vinylcarbazole) (PVK): N, N′-bis-(1-naphthyl)-N, N′-diphenyl-1, 1′-diphenyl-4, 4′-diamine (NPB)/2, 9-dimenthyl-4, 7-diphenyl-1, 10-phenanthroline (BCP)/Mg: Ag by spin coating method, which used a blend of two blue-emitting materials of PVK and NPB with different weight ratios. The luminance-voltage and current density-voltage characteristics of devices were investigated, and differences between their performances were discussed. The results demonstrate that optimum device performance could be obtained by choosing the concentration proportion of PVK: NPB at 1:1. In EL spectra of the device, except for the emission of NPB, a new emission peak at 640 nm proposed to be electroplex that formed between PVK and NPB was observed. Also, the relative emission intensity of electroplex increased with enhanced electric field. The Commissions Internationale De L'Eclairage (CIE) coordinates of Device C are x = 0.30, γ = 0.28 at 12 V, which obviously belongs to white light emission.