Relationship Between Photosynthetic Fluorescence Parameters of Algae and the Initial Biomass in the Measurement of Water Quality Biological Toxicity
Chen Min,Yin Gaofang,Zhao Nanjing,Gan Tingting,Gu Mengyuan,Qi Peilong,Ding Zhichao,Wang Lu,Feng Chun,Zhang Xiaoling
DOI: https://doi.org/10.3788/gzxb20225105.0517001
2022-01-01
Abstract:The photosynthetic fluorescence parameters of algae are easy to measure and sensitive to external stress. It is an important indicator of water quality biological toxicity measurement. However, different toxicity test schemes would lead to great differences in the toxicity data, and the stability and comparability were uncertain. Since fluorescence dynamics technology for measuring photosynthetic fluorescence parameters essentially uses optical detector to monitor the change of chlorophyll fluorescence signal in microalgae. In this paper, the concentration of chlorophyll was used as the measurement of biomass, and Chlorella pyrenoiclosa was used as the test object to analyze the relationship between photosynthetic fluorescence parameters as the end point of toxicity test and the initial biomass of toxicity test algae samples under short-term exposure (1 h and 3 h) of diuron. The results showed that: 1) When the initial biomass changes, the correlation between photosynthetic fluorescence parameters and biomass would directly affect the stability of the toxicity test results. The photosynthetic fluorescence parameters could be divided into two categories. The first category was F-v/F-m, Yield, alpha, rP, sigma(PS II) and tau(es), whose values were not related to biomass changes and only represented the photosystem information of Chlorella pyrenoidoxa. The toxicity test results obtained by these parameters were not affected by the change of initial biomass. When the initial chlorophyll concentration changed in the range of 20 similar to 1 000 mu g.L-1, 10 mu g.L-1 diuron stress for 1 h and 3 h, the average values of the corresponding relative standard deviations of the six parameter test results were 2.74% and 3.12% respectively, and the toxicity test results were stable. The second category of parameters was Ek, F-0, F-m, F-v, and JVP II . Their values were affected by biomass and contain biomass information. Among them, Ek was negatively correlated with chlorophyll concentration, and F-0, F-m, F-v and JVP II were positively correlated with chlorophyll concentration. The toxicity test results of these parameter were obviously affected by biomass fluctuation and their stability became worse. When the chlorophyll concentration changed in the range of 20 similar to 1 000 mu g.L-1, the average values of relative standard deviation of the five parameter test results under 10 mu g.L-1. diuron stress for 1 h and 3 h were 14.66% and 17.27% respectively. 2) The Logistic model was selected for dose-effect analysis, and the photosynthetic fluorescence parameters F-v/F-m Yield, alpha, rP, sigma(PS II), tau(es), F-0, F-m and F-v could establish a good dose-effect relationship with diuron. According to E-50, EC20 and correlation coefficient R-2, the optimal range of initial chlorophyll concentration of algae when photosynthetic fluorescence parameters were used as the end point of toxicity test were given. For parameters F-v/F-m Yield, alpha, rP, sigma(PS II), and tau(es) due to population dependence, too low biomass would affect the photosynthetic physiological state of algae species, the recommended initial chlorophyll concentration range was 10 similar to 2 000 mu g.L-1; for parameters F-0, Fm and Fv, more sensitive toxicity test results (lower EC50) could be obtained due to higher initial biomass, the recommended range was 200 similar to 1 000 mu g.L-1. This result provides an important basis for the establishment of a rapid detection method for water quality biological toxicity based on algal photosynthetic fluorescence parameters, and will be helpful for ecological risk assessment of the aquatic environment.