Paclitaxel-Loaded Pluronic P123/F127 Mixed Polymeric Micelles: Formulation, Optimization and in Vitro Characterization

Zhang Wei,Junguo Hao,Shi Yuan,Yajuan Li,Wu Juan,Xianyi Sha,Xiaoling Fang
DOI: https://doi.org/10.1016/j.ijpharm.2009.04.030
IF: 6.51
2009-01-01
International Journal of Pharmaceutics
Abstract:The objective of this study was to optimize and characterize a novel polymeric mixed micelle composed of Pluronic P123 and F127 loaded with paclitaxel (PTX). A Doehlert matrix design was utilized to investigate the effect of four variables, namely P123 mass fraction, amount of water, feeding of PTX and hydration temperature on the responses including drug-loading coefficient (DL %), encapsulation ratio (ER %) and the percentage of PTX precipitated from the drug-loaded mixed micelles after 48h at 37 (PTX precipitated %) for improvement of drug solubilization efficiency and micelle stability. PTX-loaded P123/F127 mixed micelles were prepared by thin-film hydration method. The optimized formulation showed a particle size of about 25nm with ER %>90%, and a sustained release behavior compared to Taxol. Micelle formation was confirmed by NMR spectroscopy. The mixed micelles had a low CMC of 0.0059% in water. In addition, micelle stability studies implied that introduction of Pluronic F127 (33wt%) into P123 micelle system significantly increased the stability of PTX-loaded micelles. More importantly, in vitro cytotoxicity was assessed using human lung adenocarcinoma cell lines SPC-A1 and A-549 and was compared to Taxol and the free drug. The cell viability assay against A-549 cells exhibited the 50% inhibition concentration (IC50) of PTX-loaded P123/F127 mixed micelles (0.1μg/ml) was much lower than those of Taxol injection (0.4μg/ml) and the free PTX (1.7μg/ml). Therefore, PTX-loaded P123/F127 mixed micelles may be considered as an effective anticancer drug delivery system for cancer chemotherapy.
What problem does this paper attempt to address?