Abstract:The effect of cold-drawing on the tensile property and giant magneto-impedance (GMI) effect of melt-extracted Co-based amorphous microwires was evaluated through detailed analyses of the distribution of residual stress and microstructural evolution. The tensile ductility and tensile strength increased gradually with cross-sectional area reduction ratio (R) until 51%, and decreased with further deformation. The microwire with R=51% exhibits the highest tensile ductility of 1.09% and tensile strength of 4320MPa. Structural and thermodynamic analyses reveal that it is the mechanical deformation rather than thermal activation that induces the precipitation of nanocrystals and arrests the quick extension of shear bands leading to the enhanced ductility. Interestingly, the GMI effect also attains the maximum value of 160% at 10MHz when R=51% (30% larger than that of the as-cast wires), before decreasing with further cold-drawing. Such an identical evolution trend of both tensile and GMI properties can be ascribed to two underlying mechanisms: the generation of longitudinal and circumferential residual stresses and the growth of deformation-induced nanocrystals during cold-drawing. The role of residual stress is established herein not only as a trigger to accelerate the amorphous-to-nanocrystalline phase transformation but also as a decisive contributor to the mechanical and GMI performance. The unique simultaneous improvement of both mechanical and GMI properties of cold-drawn Co-based microwires opens up new possibilities for a variety of engineering applications, such as high-performance magnetic, stress and biological sensors.

Influences of Extra Magnets on Giant Magnetoimpedance Effect in Amorphous Wires

Analysis of Magnetoimpedance in Amorphous Wire Passing Through A Magnetic Ring

Length Effect on Giant Magneto-Impedance in Glass-Covered Co-rich Amorphous Wire

Magnet circuit design and optimization of giant magnetostrictive transducer

Optimized Giant Magnetoimpedance Effect In Amorphous And Nanocrystalline Materials

Effect of Annealing Temperature on Permeability and Giant Magneto-Impedance of Fe-based Amorphous Ribbon

Giant Magnetoimpedance Effect in a Co-Based Microwire for Quick-Response Magnetic Sensor Applications

Valve Behavior Of Giant Magnetoimpedance In Field-Annealed Co70fe5si15nb2.2cu0.8b7 Amorphous Ribbon

Simulation of Magnetic End Effect of Amorphous Wires

Giant Magneto-Impedance and its Applications

Combined Current-Modulation Annealing Induced Enhancement Of Giant Magnetoimpedance Effect Of Co-Rich Amorphous Microwires

Effect of Tension Annealing on Giant Magneto-Impedance in Glass-Covered Co-rich Amorphous Wire

Ultra-large Giant Magnetoimpedance Effect by a 2D Square Spiral Amorphous Microwire

A New Magnetic Sensor Based on Giant Magneto- impedance Effect of Fe-based Amorphous Wire

Surface microstructural design to improve mechanical and giant magneto-impedance properties of melt-extracted CoFe-based amorphous wires

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

Giant Magneto-Impedance Effect on Nanocrystalline Microwires with Conductive Layer Deposit

Optimizing magnetoimpedance of amorphous microwires by nanocarbon-induced magnetic anisotropy

Large GMI effect in Co-rich amorphous wire by tensile stress

Modeling of torsion stress giant magnetoimpedance in amorphous wires with negative magnetostriction

Collective Length Effect on the Magnetostatic Properties of Arrays of Glass-Coated Amorphous Alloy Microwires