Study on Π-Π Stacking Between Asphaltene Molecules by DFT and MM Methods
LUO Hui,Lü Huidong,ZHOU Jiaanqi,DENG Wenan,LI Chuan,NAN Guozhi
DOI: https://doi.org/10.3969/j.issn.1673-5005.2023.01.022
2023-01-01
Abstract:To gain insight about the π-π stacking in asphaltene molecular aggregates, density functional theory（DFT） and molecular mechanics（MM） methods were adopted to study the potential energy surface（PES）, the equilibrium center of mass distance（R e ） and the equilibrium interaction energy（ΔE e ）. The results show that the typical PES are obtained to describe the S-type（sandwich）, T-type（T-shaped） and PD-type（parallel-displaced） dimers of benzene or asphaltenes by using DFT-D, DFT/mGGA, MM, or DFT/GGA with DNP+ basis set, where the DFT/mGGA-M06L method has the highest accuracy. The ΔE e and R e calculated by mGGA-M06L are consistent with those reported in the literature for benzene dimers, and the errors are less than 4.60%. The R e of the S-type asphaltene dimer is very close to that of benzene, both are 0.388 nm, and ΔE e is more than ten times larger than that of benzene. For the T-type asphaltene dimers, the more atoms in the short-distance, the greater the ΔE e , but there is only one or several atoms in the short-distance, resulting in the ΔE e significantly smaller than that of the S-type dimer. The ΔE e of the PD-type asphaltene dimers are greater than that of the S-type, and the ΔE e is the largest when the vertical distance（R v ） is about 0.35 nm, which is close to twice that of the S-type. In this case, the interlamellar spacing of the dimer is significantly smaller than that of the S-type, resulting in the most stable structural conformation.