Abstract:Numerical simulation is an important method to study the penetration into targets. Distinct results may be acquired if different kinds of software are adopted. In this paper, three kinds of commonly-used softwares (LS-DYNA, ABAQUS and PAM-CRASH) were adopted to simulate the same series of penetration experiments. The simulation results were analyzed and the advantages and disadvantages of each kind of software were compared. The purpose of this work is to help the researchers and engineers to select the most suitable software. The results in this paper demonstrate that the calculation results of the three kinds of software are basically consistent with the experimental results. The simulation results of the flat-headed projectile are generally better than those of the hemispherical projectile. The residual velocity of the projectile and the plug velocity were simulated well using all of the three kinds of software. The calculated velocities by ABAQUS and PAM-CRASH are closer to the experimental results, and the average relative errors are generally lower than 15%. Moreover, the errors from most calculation results by PAM-CRASH are even less than 10%. However, for the deformation of the projectile, the calculation results of the three kinds of software are quite different from the experimental ones. There are other differences in the performance of the three kinds of software. For example, the ballistic limits calculated by ABAQUS and LS-DYNA are higher than the experimental results, while those by PAM-CRASH are lower. ABAQUS is most likely to report errors but is balanced by calculation time and effects. LS-DYNA has a low error rate and good robustness. The change of model parameters (such as mesh density, friction coefficient, contact stiffness, viscous damping coefficient, etc.) has little effect on its calculation results. PAM-CRASH is greatly affected by model parameters. The conclusion of this paper is based on the following conditions: the target material is Weldox 460E steel, the projectile is ARNE tool steel, and the impact velocity range is 180－450 m/s. However, it is also of guiding significance for the penetration problem simulation of other materials in this velocity range.

The Analysis on Penetration Effectiveness of Supersonic Cruise Missile Countering Interceptor Based on Killing Zone

Combat Effectiveness Modeling and Evaluation of Hypersonic Cruise Missiles

Simulation Analysis for Penetration Effectiveness of Cruise Missile Counter Measuring Phased-Array Radar

Penetartion Analysis of Hypersonic Cruise Missile Against Radar

Estimation the Mission Effectiveness of Hypersonic Cruise Missile in Conceptual Design

Numerical Investigation of Transient Lateral Jet Interaction in A Supersonic Interceptor Missile

Research on Efficiency of Cruise Phase of TV-guided Air-to-surface Missile

Validity Analysis on Coordination Interception of Missile Defense System

Study about Hypersonic Cruise Missile Combat Engagement Simulation

The Effectiveness Analysis of Multi-Target Penetration in Ballistic Missile Attack

Research on Penetration Ability of Wavy Trajectory Missile

Simulation Analysis of Radar Cross Section for Drone of a Certain Cruise Missile

Research of the Penetration by Ballistic Missile's Maneuver When is Intercepted by KKV

Research on Penetration Probability of Missile Weapon System Based on Simulation

Study of Soft-killing Effectiveness Evaluation for Aerodynamic Missile Weapon Systems

Attack-Defense Countermine of Analysis on Hypersonic Weapon

Three-dimensional Modeling and Simulation for Air-to-air Missile's Killing Probability

Penetration Analysis of Driving Weapons Precursory Shaped Charge Based on LS-DYNA

Hypersonic Vehicles Against a Guided Missile: A Defender Triangle Interception Approach

A Method for Evading Penetration and Guidance of the Hypersonic Missile

Comparative study of numerical simulations of projectile penetration into metal targets