Abstract:Unlike individual unmanned aerial vehicles (UAVs), integrated aerial platforms (IAPs) containing multiple UAVs do not suffer from underactuation and can move omnidirectionally in six dimensions, providing a basis for constructing aerial manipulation platforms. Compared to single UAVs, multi-UAV IAPs are also advantageous in terms of payload and fault-tolerance capacity, making them promising candidates as platforms with integrated-response, observation, and strike capabilities. Herein, an IAP structure design containing three sub-UAVs connected in a star-like configuration is presented. This form of integration enables the IAP, as a whole, to simultaneously adjust its position and attitude in six dimensions. The dynamics of the overall system of the IAP are modeled. On this basis, an overall system controller is designed. To simplify control, based on stability of cascaded system, the rotational motion of the sub-UAVs is treated as a inner-loop subsystem, whereas the overall motion of the IAP is seen as a outer-loop subsystem. Because the configuration space of the sub-UAVs is non-Euclidean, a controller is designed for the outer-loop subsystem based on model predictive control on the manifold. Subsequently, the stability of the closed-loop system is demonstrated. Fieldbus technology is employed to design a real-time, scalable communication architecture for multiple sub-UAVs, followed by the development of a principle prototype of the multi-UAV IAP that consists of hardware and software systems. The effectiveness of the IAP design and control method is validated through simulation and real-world prototype-based tests. In the simulation and real-world tests, the proposed methodology can make the IAP system converge to the desired configuration at the presence of large initial configuration error. The same test scenario cannot be finished by a baseline PID controller. The advantage of the proposed control scheme in dealing with state and input constraints is shown via such tests.

Collaborative Simulation and Integrated CMAC and PID Optimization and Control of an Aerial Work Platform

Generalized predictive adaptive control and combination of simulation of aerial work platform

Nonlinear Control of Long-pipe Valve-controlled Asymmetrical Cylinder System

Research on Dynamic Performance of Aerial Work Platform Leveling Chain Transmission

Levelling Control of an Electro-pneumatic Stabilized Platform Driven by Pneumatic Muscles

Dynamic Response of DP Offshore Platform-Riser Multi-Body System Based on UKF-PID Control

Cross-coupling Integral Adaptive Robust Posture Control of a Pneumatic Parallel Platform

Integral Backstepping-based Nonlinear Flight Control Strategy for Quadrotor Aerial Robot with Unknown Mass

Modeling and Adaptive Robust Posture Control of 3-Rps Pneumatic Parallel Platform

Robust Pid Controller Design Using Co-Evolutionary Particle Swarm Optimization

Expert-PID Synchronization Control of Thrust Hydraulic System

Adaptive Robust Posture Control of A 3-Rps Pneumatic Parallel Platform with Unknown Deadzone

Design, Modeling and Dynamic Compensation PID Control of a Fully-Actuated Aerial Manipulation System

Fuzzy-immune PID Control of a 6-DOF Parallel Platform for Docking Simulation

Adaptive sliding-mode trajectory-tracking control of hydraulic Stewart platform

PID–PFC control of continuous rotary electro‐hydraulic servo motor applied to flight simulator

A Hybrid Control Method for an Unmanned Scale Helicopter Attitude

Full control of a quadrotor using parameter-scheduled backstepping method: implementation and experimental tests

A Particle Swarm Optimization Approach For Pid Parameters In Hydraulic Servo Control System

Design and Implementation of a Fully-Actuated Integrated Aerial Platform Based on Geometric Model Predictive Control

Research on Control Strategy of Electro-Hydraulic Lifting System Based on AMESim and MATLAB