Abstract:In a steam turbine system, one of the main factors limiting the operational flexibility is the thermal stress associated with a high-temperature gradient within the control valves, which often leads to structural damage during frequent startup and shutdown cycles. One possible solution is to utilize an electric heating system with appropriate insulation to decrease the warm-up time. Here, an experiment and a numerical simulation were performed using a scaled turbine valve equipped with an electric heating system to understand the heat transfer process. The experiment, which was conducted at Shanghai Jiao Tong University, had a duration of 100 h and included three heating-cooling cycles and two heat preservation states. The results showed that the temperature distribution of the scaled valve was uniform, which is due to the high thermal conductivity of the valve body and the low conductivity of the insulation layer. The simulation, which used the commercial software ansys fluent 2019 R1, was performed to model the experimental heat transfer process and showed less than 10% deviation from the measured temperatures. A sensitivity study revealed that the valve temperature is very insensitive to the heat transfer coefficient of the outer surface of the insulation layer, which is attributed to the negative feedback regulation of radiation heat transfer. To further improve the computing efficiency, a simplified model based on the lumped parameter method and the quasi-steady-state assumption was proposed and validated. This model can predict the 100 h valve temperature history in less than 1 min and showed good agreement for all of the studied cases. The ability of the simplified model to simulate the valve heating-cooling cycles at a high efficiency could accelerate the thermal design process to improve the operational flexibility of steam turbines in the future.

Numerical Simulation of Temperature Field and Stress Field of the Valve Box of a Steam Turbine

Simulation and analysis of dynamic heat transfer inside a cryogenic valve under cryogenic test

The Numerical Analysis Of Ventilation And Temperature Fields For A Bulb Tubular Turbine Generator

FEM-based Multi-field Coupling Stress Analyses of the Cylinder-bolts System in a Gas Turbine Power Plant

Numerical Study On Temperature Field And Spool Deformation Of Throttle Slide Valve With V-Notches

TEMPERATURE FIELD AND THERMAL STRESS FINITE ELEMENT ANALYSIS OF A 50MW STEAM TURBINE'S CYLINDER IN A POWER PLANT

Analysis of the Temperature and Stress Field in a Steam Turbine Bypass Valve Body

A Comprehensive Heat Transfer Study Inside a Steam Turbine Valve: Experiment, Numerical Simulation, and Simplified Model

2D Non-Steady Numerical Simulation on Opening Process of Control Valve for Supercritical Steam Turbines

Numerical Simulation on Fluid Dynamic Behavior of High-pressure Safety Valves

Transient Thermal Behaviors of Ultra-Supercritical Steam Turbine Control Valves During the Cold Start Warm-Up Process: Conjugate Heat Transfer Simulation and Field Data Validation

NUMERICAL SIMULATION OF 3D VISCOUS FLOW IN THE HIGH-PRESSURE VALVE OF A 600MW STEAMTURBINE

Study on Heat-transfer Behavior of High-pressure Inlet Valve for Large Steam Turbines During Cold Start-up Process

Thermo-mechanical Stress Analysis of Feed-Water Valves in Nuclear Power Plants

The Temperature and Thermal Stress Analysis of Steam Pipe and Correlative Branch Pipe with Finite Element Method

Evaluation of the Viscous Heating Induced Jam Fault of Valve Spool by Fluid–structure Coupled Simulations

Numerical model for steamtight analysis of high pressure casing of turbine

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Numerical Investigation of Flow Characteristic of Control Valve of Steam Turbine in the Entire Range of Operating Mode

Investigation On Flow Characteristics And Stability Of Control Valves For Steam Turbines

Study of Three-dimensional Steady Numerical Simulation for 600MW Supercritical Steam Turbine Governing Valve