Abstract:The present study presents an attempt to modify the surface properties of macroporous resins (MRs) in order to improve anthocyanin adsorption and desorption from Pyrus communis var Starkrimson fruit peel extract. A number of MRs were tested to optimise the ultrasonic-assisted adsorption (UAA) conditions; including ultrasonic power (100-400 W), resin-to-extract ratio (1-3 g/50 mL) and temperature (20-40 degrees C). Similarly, varying ultrasonic-assisted desorption (UAD) conditions were optimised; including ultrasonic power (200-600 W), resin-to-solvent ratio (1-4 g/50 mL), ethanol concentration (60-90% v/v) and temperature (20-40 degrees C). The Amberlyst 15 (H) cationic resin was found to be superior to the other tested resins. The maximum adsorption capacity (659 mu g/g) of cyanidin 3-galactoside (Cy 3-gal) was achieved under the optimised UAA conditions (400 W, 20 degrees C and 1 g/50 mL), while 616 mu g/g of Cy 3-gal was recovered under the optimised UAD conditions (582 W, 1 g/50 mL, 60% and 20 degrees C). Moreover, titratable-acid and total-sugar contents were found to be significantly lower under UAA than under conventional-assisted adsorption (CAA). ANOVA revealed that process factors had significant effects on the Cy 3-gal purification, as depicted by their linear, quadratic and interactive effects. While anthocyanin adsorption was found to be significantly improved at lower ultrasonic power, higher power promoted the desorption process. Adsorption under optimized UAA conditions followed pseudo second-order kinetics and multilayer adsorption (Freundlich isotherm) onto the Amberlyst 15 (H) resin surface was observed. The particle-size distribution curve and scanning electron microscopic images also revealed higher resin-surface roughness, peeling and the appearance of pores on the surface under ultrasonication. This is the first study to use ultrasonication to modify a cationic exchange resin for the improvement of Cy 3-gal purification from a fruit extract. This study can recommend the use of ultrasonication as a low-cost green technique that can improve macroporous resin characteristics for better purification of compounds from an extract

Study on microwave assisted synthesis of glucose pentaacetate catalyzed by macroporous resin

Highly Efficient One-Pot Conversion of Glucose to 5-Hydroxymethylfurfural over Acid–Base Bifunctional MCM-41 Mesoporous Silica under Mild Aqueous Conditions

Ultrasonic-assisted Modifications of Macroporous Resin to Improve Anthocyanin Purification from a Pyrus Communis Var. Starkrimson Extract

Microwave Enhanced Catalytic Hydration of Acrolein to 3-Hydroxypropionaldehyde Using Simultaneous Cooling: Experimental and Theoretical Studies

Microwave-Assisted Synthesis of Alkyl Glucopyranosides

Synthesis of acetals and ketals catalyzed by HMAS-5 molecular sieve

Microwave-assisted Catalytic Dehydration of Glycerol for Sustainable Production of Acrolein over a Microwave Absorbing Catalyst

Microwave-assisted Efficient Synthesis of Glucose-Based 3-Acetyl-5-alkyl-2,3-dihydro-1,3,4-oxadiazole Derivatives Catalyzed by Sodium Acetate.

Synthesis of Isoamyl Butyrate by Macroporous Resin As Catalyst and Microwaves Induction

Selective HMF synthesis from glucose via microwave-assisted metal chloride catalysis

Microwave initiated synthesis and application of polyacrylic acid grafted carboxymethyl cellulose

Synthesis of an Amphiphilic Glucose‐carrying Graft Copolymer and Its Use for Membrane Surface Modification

Fabrication of lignin-derived mesoporous carbon/magnesium oxide composites for microwave-assisted isomerization of glucose in water

Sustainable Production of Gluconic Acid and Glucuronic Acid via Microwave-Assisted Glucose Oxidation over Low-Cost Cu-Biochar Catalyst

Study on catalytic synthesis of fructone

Synthesis of Ethyl p-Hydroxybenzoate Catalyzed by Activated Carbon Supported Tungstosilicic Acid under Microwave Irradiation

Microwave Assisted Grafting Technique for Modification of Polysaccharides

Microwave-assisted Synthesis of Acrylamide Grafted Polymeric Blend of Fenugreek Gum and its Characterization

Sustainable production of gluconic acid and glucuronic acid via microwave-assisted glucose oxidation over low-cost Cu-biochar catalysts

Study on novel technology for green synthesis of butyl paraben

High-yield, fast, and green synthesis of acridine derivatives using a Co/C catalyst from rice husks with a microwave-assisted method