Abstract:To investigate the influence of the overlapping process on the distribution of Cr during the laser cladding process, a novel three-dimensional melting and solidification model based on the volume-average method coupled with Eulerian-Eulerian multiphase was established to simulate the process of laser cladding on a 45# steel substrate with different overlapping processes of 316 L powders. The reliability of the model was verified by comparing the simulation results with the melt pool morphology and melt flow rate measured by a high-speed camera. The height and depth of melt pool were verified through the cross-sectional metallographic diagram. The deviations of the melt pool height and depth for single-path cladding were 2.49 % and 6.35 %, respectively, while the deviations for overlapping process were 8.26 % and 6.88 %, respectively. The deviations of melt flow rate were 12.8 % for single-path cladding and 10.0 % for overlapping, respectively. The distribution of chromium (Cr) was verified based on the results of energy-dispersive spectroscopy (EDS), which demonstrated the accuracy of the model. The results demonstrate that reducing the overlapping rate during the overlapping process will increase the dilution rate of the second path of the molten cladding layer which in turn will decrease the concentration of Cr in the lapped area. Reverse overlapping, on the other hand, increases the temperature of the molten pool and the flow rate of the melt, resulting in a more homogeneous mixing of the elements within the second path of the cladding layer. This reduces the difference between the elemental concentration in the lapped area and the elemental concentration of the first and second paths of the cladding layer.

Study on Overlapping in the Laser Cladding Process

Numerical Simulation of Multi-Track Laser Cladding Process

Optimization model of overlap rate of laser cladding based on Gaussian function and top tangent model

Influence of overlapping process on the distribution of Cr element in laser cladding 316L powder on 45# steel substrate

Numerical research on effect of overlap ratio on thermal-stress behaviors of the high-speed laser cladding coating*

Optimization method for the overlap rate of laser cladding using a variable fitting function

Temperature Field Simulation and Experimental Analysis of Laser Cladding 45 Steel.

Study of the effect of overlap rate on the failure form, microstructure and wear resistance of multilayer laser cladding on grey cast iron surfaces

Correlation research on multi-field coupling of multi-track overlapping laser cladding process for nodular cast iron

Influence of Process Parameters on Flatness During Single-Track Laser Cladding

Quantitative analysis and experimental study of the influence of process parameters on the evolution of laser cladding

Numerical simulation and experimental study on the heat and mass transfer behavior during the pulsed laser cladding process

Analysis and Respond Surface Methodology Modeling on Property and Performance of Two-Dimensional Gradient Material Laser Cladding on Die-cutting Tool

Effect of overlap rate on the microstructure and corrosion behavior of pure copper laser cladding

Optimization of Process Parameters of Laser Cladding 304L Alloy Powder Based on Orthogonal Experiment

The overlap rate influences the microstructure and properties of laser-cladded Fe-Ni-Ti composite coatings

Flow-accelerated corrosion mechanism of overlap and non-overlap zones in multi-track laser-clad nickel-based alloy coating

Effect of different overlap cladding transition layer - austenitic stainless steel coating and defect degree on corrosion resistance

Influence of Process Parameters on the Quality of Bionic Non-Smooth Coatings by Laser Cladding

Numerical simulation of thermal transfer and flow behavior of Ni60AA formed by laser cladding

Effects of Overlapping Distances on Steel Microstructure and Properties After Multi-track Laser Quenching