Abstract:Dimethyl carbonate (DMC) is a promising green chemical that plays a significant role in the sustainable chemical industry, clean energy technologies, and environmental protection. In response to the challenges of high equipment investment and energy consumption in the existing process for producing dimethyl carbonate through an ester exchange reaction using vinyl carbonate and methanol, a new reactive dividing-wall column (RDWC) process was developed. A new RDWC model was established by using Aspen Plus. The impact factors of reaction conditions such as reactant molar ratio, theoretical number of reaction stages, reaction pressure, and separation conditions such as theoretical number of common rectifying section, theoretical number of common stripping section, liquid phase distribution on both sides of the dividing wall, and side draw location were analyzed. A laboratory-scale new RDWC was designed and built referenced to the simulation results. The experimental research investigated key parameters affecting the reaction distillation column, such as the reaction zone height, reactant molar ratio, liquid phase distribution, reflux ratio, and vapor phase distribution on both sides of the dividing wall. This research laid the foundation for the scale-up designing of process parameters for the new RDWC. Under optimized conditions, the conversion rate of reactant EC (ethylene carbonate) exceeded 99.9%, the purity of methanol in the side draw was at least 99 wt %, and the purity of methanol ethylene glycol in the distillation column achieved a concentration greater than 99% (excluding the catalyst). The new method can greatly shorten the transesterification process (integrate the three towers in the original process into one) to produce dimethyl carbonate, save investment, and reduce energy consumption.

Dynamic simulation of start-up procedure for the production of ethylene glycol monobutyl ether via catalytic distillation column

Dynamic Simulation and Control schemes of hybrid membrane-distillation process on ethylene- ethane system

MODELING OF BATCH DISTILLATION STARTING FROM COLD STATE

Modeling and Analysis of New Reactor Concepts for Poly(ethylene Terephthalate) Esterification Process

A startup model for simulation of batch distillation starting from a cold state

Stability and dynamic behaviors of gas-phase ethylene polymerization process under condensed mode operation

Simulation-Based Multiobjective Optimization Of The Product Separation Process Within An Mtp Plant

Research on Rigorous Mechanism Modeling for Distillation Column Series under Wide Variation of Feed Condition

Nonequilibrium model and parameter estimation on three-phase distillation in a packed column

Optimization of Internal Thermally Coupled Distillation Columns of Nonideal Mixture

Influence of Operating Conditions on the Hybrid Separation Process Used for C4 Etherified Products

Process Simulation, Thermodynamic and System Optimization for the Low-Carbon Alcohols Production Via Gasification of Second-Generation Biomass

Large-scale Equation Oriented Dynamic Simulation of Ethylene Separation Columns

Simulation and Optimization of Distillation Column Sequence in Large-Scale Ethylene Production

Compartmental modeling and solving of large-scale distillation columns under variable operating conditions

Modelling and simulation of multicomponent acetone-butanol-ethanol distillation process in a sieve tray column

Intelligent Operation Optimization of Distillation Column for Debutanization in Ethylene Process

Study on a New Reactive Dividing-Wall Column for the Reaction of Vinyl Carbonate and Methanol Ester Exchange to Produce Dimethyl Carbonate

The Model of Catalytic Reactor of Ethylene Glycol Production

Separation of Ternary System 1,2-Ethanediol + 1,3-Propanediol + 1,4-Butanediol by Liquid-Only Transfer Dividing Wall Column

The Start-up of a Multiple Dividing Wall Column – A theoretical and experimental study