Abstract:Most of the existing numerical models for falling film dehumidifiers consider two-dimensional adiabatic-type models. However, the performance of the adiabatic type dehumidifier is relatively poor, in addition to the fact that the two-dimensional model cannot well represent the flow process of liquid desiccant and the dehumidification process in the actual operation of the dehumidifier. Therefore, in order to better study the falling film of liquid desiccant and the heat and mass transfer process inside the tube, this paper established a three-dimensional model of the evaporative cooling falling film dehumidifier with higher dehumidification performance outside the tube based on CFD technology. The results showed that the simulation results of the constructed model were in good agreement with the experimental results, and the average relative error about 12 %. The out-of-tube evaporative cooling system cooled the dehumidifier through the combined effect of droplet evaporation and low-temperature liquid film on the outer wall surface. Under the baseline conditions: the dehumidification performance of the solution outlet section was better than that of the solution inlet section. The best cooling effect and dehumidification performance was achieved when the flow rate of shower water was 0.25 kg/(m 2 ·s) and the flow rate of evaporative cooling air was 0.3 m/s. The dehumidification performance at a solution inlet velocity of 0.01 m/s was 79 % of that at 0.06 m/s; even if the solution flow rate was small, evaporative cooling dehumidifier still had a good dehumidification performance. The results of this paper provided a reference for the design of evaporative cooling type solution dehumidifier.

Development and verification of the heat and mass transfer model for tube-type indirect evaporative air cooler

Development and Validation of Helical-Coil-in-fluted-tube Gas Cooler for CO2 Heat Pump Water Heaters

Numerical Heat and Mass Transfer Analysis of a Cross-Flow Indirect Evaporative Cooler with Plates and Flat Tubes

An Experimental Study on the Heat and Mass Transfer Characteristics of an Evaporative Cooler

Two-dimensional Numerical Study of a Heat and Mass Exchanger for a Dew-Point Evaporative Cooler

Mathematical Model and Analytical Solution of Heat and Mass Transfer Processes in Plate Evaporative Cooler

Heat Transfer Model and Simulation of Large Industrial Evaporative Cooler

The Heat And Mass Transfer Characteristics In A Vertical-Tube Evaporative Condenser

Statistical Modeling and Multi-Objective Optimization of a Flat Tubular Indirect Evaporative Cooler for Enhanced Performance

Theoretical Analysis Of Indirect Evaporative Cooler With Separate Type Heat Pipe Applied On Ventilation

Experimental and numerical investigation of the temperature and humidity distribution inside the channels for a regenerative indirect evaporative cooler

Numerical modeling and experimental validation of heat and mass transfer inside charge air coolers with water condensation

Mass Transfer outside a Horizontal Tube for an Indirect Evaporative Cooler

Experimental Study of the Performance of Tube Evaporative Cooler with Water Absorbent Film on the Surface

STUDY ON EVAPORATIVE COOLING OF FALLING FILM COUPLED WITH HEAT AND MASS TRANSFER

Analysis of Transfer Model for Plate Evaporative Air Cooler Based on Wet Bulb Temperature

Study on the performance of tube evaporative cooling dehumidifier based on CFD

Heat and mass transfer of evaporative cooler with elliptic tube heat exchangers- an experimental study

Development and Validation of a Microchannel Evaporator Model for a CO 2 Air-Conditioning System

Experimental study on the flow resistance of inner tube and characteristics of drifting water in a tubular indirect evaporative cooler

The Heat and Mass Transfer Process of the Counter-Flow Dew Point Evaporative Cooler