Abstract:A series of mesoporous H beta zeolites with low crystallinity and various Si/Al ratios were prepared using different Si/Al ratios in the reactants. Then, NiMoC/H beta-x catalysts (x = 15, 18, 23, 27 and 30) were prepared using a co-impregnation method followed by temperature-programmed reduction under a H-2/CH4 atmosphere. The effects of the initial Si/Al molar ratio on the chemical compositions, textural properties, acidities and morphologies of these materials were investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), X-ray fluorescence (XRF), N-2 adsorption-desorption, temperature-programmed ammonia desorption (NH3-TPD), FTIR spectroscopy of adsorbed pyridine (Py-FTIR), H-2-temperature programmed reduction (H-2-TPR), high resolution transmission electron microscopy (HRTEM) and X-ray photoelectron spectroscopy (XPS). The catalytic performance towards the hydrogenation of naphthalene was tested with and without quinoline in a fixed-bed reactor, and then evaluated by hydrogenation of aromatics from low temperature coal tar (LTCT). The results showed that the total acidity, the number of Bronsted acid sites and Lewis acid sites, and the molar ratio of Bronsted to Lewis acid sites (B/L) decreased with increasing initial Si/Al ratio for the pure H beta-x zeolites and their corresponding supported NiMoC catalysts. The NiMoC/H beta-18 catalyst had the best catalytic activity among the prepared catalysts and a strong tolerance to heteroatom compounds in the hydrogenation of aromatic compounds. It could be concluded that the total acidity of the catalyst and the dispersion of the active metal served as crucial factors that determined the catalytic performance toward aromatics hydrogenation.

Investigation of reaction conditions for hydrogenation of NBR solution using hydrogen storage alloy as catalyst

Study on the Ni Supported Catalysts Used for Hydrogenation of IPN to Produce MXDA

Reaction Kinetic and Mechanistic Studies on Hydrogenation of NBR Catalyzed by Hydrogen Storage Alloy

Supported Nanometric Platinum–nickel Catalysts for Solvent-Free Hydrogenation of Tetralin

Study on Hydrogention of Acrylonitrile-Butadiene Rubber Catalyzed by MlNi5-x(CoMnAl)x

Experimental and Theoretical Investigation on the Enhanced Hydrogen Storage Performance of Ti–Cr–Mn–Fe-Based Alloys Modified by Nb Substitution

Hydrogention of conjugated diene polymers catalyzed by hydrogen storage alloys

Kinetic study on hydrogenation of NBR catalyzed by intermetallic compounds

Liquid-phase hydrogenation of m-chloronitrobenzene over Ni-M-P amorphous alloy catalyst

Homogeneous catalytic hydrogenation of hydroxyl-terminated liquid nitrile rubber

Improving MgH2 formation kinetics and its effect on NaBH4 synthesis

Hydrogen storage capabilities of the alloys Fe 0.85Mn 0.15Ti 0.9M 0.1 (M=Zr, V, Ca)

New Method for Hydrogenating Nbr Latex

Kinetics of liquid-phase hydrogenation of toluene catalyzed by hydrogen storage alloy MlNi(5)

Investigation of Hydrogen Storage Properties on the Mg-La-Ni Alloy Compounded with C@Pr2O3 Composite Catalyst

The Promoted Catalytic Hydrogenation Performance of Bimetallic Ni-Co-B Noncrystalline Alloy Nanotubes

Effect of Co-B Supporting Methods on the Hydrogenation of M-Chloronitrobenzene over Co-B/CNTs Amorphous Alloy Catalysts

Effect of initial Si/Al ratios on the performance of low crystallinity Hβ-x zeolite supported NiMo carbide catalysts for aromatics hydrogenation

Influence of Alloying Platinum for the Hydrogenation of Chloronitrobenzene over PtM/ZrO2catalysts with M=Cr, Mn, Fe, Co, Ni, Cu

Preparation of Raney Ni Catalyst and Research on Its Catalytic Hydrogenation Performance for Alkenyl Aromatics

Diffusion controlled hydrogen desorption reaction for the LiBH4/2LiNH2 system