Abstract:With the proliferation of RFID-enabled applications, multiple RFID readers (or reader antennas) must be used to provide full coverage to any deployment area beyond the communication range of a single reader. However, reader collision together with tag-to-tag collision seriously degrades the system performance or even blocks out some tags from being read. To address this problem, this paper proposes a time-efficient protocol stack that is tailored to the tag identification in a multi-reader RFID system, which consists of two protocols: one is for eliminating reader collision (RCE) and the other is for avoiding tag-to-tag collision (TCE). In RCE, we enable multiple readers to work in parallel for maximizing the number of tags to be read per unit of time. Where RCE shines is that it well addresses the problem of unbalanced load by each reader due to uneven tag distributions. Namely, in existing work, the readers with fewer tags covered will finish the tag identification earlier than other readers (with more tags). After that, these readers have to wait for all readers until they are done. This is a waste of time. The solution of RCE is to take the reader with the minimum number of tags as the reference and iteratively to update the set of concurrent readers. Besides, in TCE, we use bit-level tag response to resolve tag-to-tag collision and increase the number of useful slots, so does the read throughput. Theoretical analysis and simulation results show that the above two protocols can jointly improve the inventory efficiency and reduce the identification time by more than 50%, in comparison to the state-of-the-art. We validate TIMR’s performance by comparing its results on a real-world library data set with simulated data, demonstrating consistency across both settings.

ASAP: Scalable Collision Arbitration for Large RFID Systems.

ASAP: Scalable Identification and Counting for Contactless RFID Systems

Collision-Aware Churn Estimation in Large-Scale Dynamic RFID Systems.

Collision-Aware Churn Estimation in Large-Scale Dynamic RFID Systems

Double-mode Blocking Anti-Collision Algorithm in RFID Tags

Adaptive Distributed Reader Activation Approach for Large-Scale RFID Systems

Achieving Collision Freedom Without Modifying Communication Protocols in Wireless Rechargeable Sensor Networks.

Master-slave Dual Readers Enhanced Aloha Anti-Collision Mechanism for Dense Active RFID

Shelving Interference and Joint Identification in Large-Scale RFID Systems

A Novel Anti-Collision Algorithm for Large Scale of UHF RFID Tags Access Systems

A Protocol Stack for Large-Scale RFID Systems: Mitigating Reader and Tag Collisions

STEP: A Time-Efficient Tag Searching Protocol in Large RFID Systems

Dual-Reader Wireless Protocols for Dense Active Rfid Identification

A hybird CDMA-IDMA anti-collision protocol for dense RFID system

A Collision Arbitration Protocol Based on Specific Selection Function

An RFID multi-Tag anti-collision algorithm based on Successive Interference Cancellation with power adaptive regulation

Revisting Tag Collision Problem in RFID Systems

Adaptive and dynamic RFID tag anti-collision based on secant iteration

Complete and Fast Unknown Tag Identification in Large RFID Systems

A Novel Cross Layer Anti-Collision Algorithm for Slotted ALOHA-Based UHF RFID Systems

Wonder: Efficient Tag Identification for Large-Scale RFID Systems