Abstract:This paper deals with the problem of energy utilization efficiency evaluation of a microturbine system for Combined Cooling, Heating and Power production (CCHP). The CCHP system integrates power generation, cooling and heating, which is a type of total energy system on the basis of energy cascade utilization principle, and has a large potential of energy saving and economical efficiency. A typical CCHP system has several options to fulfill energy requirements of its application, the electrical energy can be produced by a gas turbine, the heat can be generated by the waste heat of a gas turbine, and the cooling load can be satisfied by an absorption chiller driven by the waste heat of a gas turbine. The energy problem of the CCHP system is so large and complex that the existing engineering cannot provide satisfactory solutions. The decisive values for energetic efficiency evaluation of such systems are the primary energy generation cost. In this paper, in order to reveal internal essence of CCHP, we have analyzed typical CCHP systems and compared them with individual systems. The optimal operation of this system is dependent upon load conditions to be satisfied. The results indicate that CCHP brings 38.7 percent decrease in energy consumption comparing with the individual systems. A CCHP system saves fuel resources and has the assurance of economic benefits. Moreover, two basic CCHP models are presented for determining the optimum energy combination for the CCHP system with 100kW microturbine, and the more practical performances of various units are introduced, then Primary Energy Ratio (PER) and exergy efficiency (alpha) of various types and sizes systems are analyzed. Through exergy comparison performed for two kinds of CCHP systems, we have identified the essential principle for high performance of the CCHP system, and consequently pointed out the promising features for further development.

Typical Characteristics of Gas Turbine-Based CCHP System with Inlet Air Cooling

Technical Performance and Cost-effectiveness of Gas Turbine Inlet Air Cooling Systems

Effects of Different Alternative Control Methods for Gas Turbine on the Off-Design Performance of a Trigeneration System

Performance Analysis of the Combined Cooling Heating and Power System (CCHP) based on Internal Combustion Engine,Gas Turbine and Micro Gas Turbine

Evaluation Of Energy Efficiency For A Cchp System With Available Microturbine

The Performance Improvement Of A 70kwe Natural Gas Chp System

Energy, exergy, energy-saving, economic and environmental analysis of a micro-gas turbine-PV/T combined cooling, heating and power (CCHP) system under different operation strategies: Transient simulation

Performance Analysis of Fogging Cooled Gas Turbine With Regeneration and Reheat Under Different Climatic Conditions

Thermodynamic Performance Assessment of CCHP System Driven by Different Composition Gas

The Engineering Practice of A Cchp System with the Condensation Heat Recovery of the Flue Gas in China

Effect of Inlet Air Heating on Gas Turbine Efficiency under Partial Load

A Novel Inlet Air Cooling System to Improve the Performance of Intercooled Gas Turbine Combined Cycle Power Plants in Hot Regions

Application Study Of A Cchp System Operating With The Flue Gas And Geothermal Energy

Performance Research of a Micro-CCHP System with Adsorption Chiller

Performance study of an innovative natural gas CHP system

The exergy and energy level difference graphic analysis of a CCHP system under compressor inlet air throttling (IAT) operating strategy

Energetic, Exergetic and Economic Analysis of a Trans-Critical Solar Hybrid CCHP System

Performance Improvement of a 70 Kwe Natural Gas Combined Heat and Power (CHP) System

Comparison of the application in CCHP between gas turbine and gas engine

Parametric Analysis of a New CCHP System Utilizing Liquefied Natural Gas (LNG)

Performance Evaluation Case of a Gas Turbine-based Heat-and-Power Cogeneration System