Abstract:In this article, a numerical simulation of the droplet formation in a Co-flow microchannel capillary device, and the influencing factors of the formation of droplets are studied. The level set method is used to track the two-phase interface and droplet formation. In the Co-flow focusing device, we explored the influencing factors of the size of the generated droplets. In the Co-flow focusing device, we explored the influences of various factors on the droplet size, generation frequency, and the droplet pressure at the centerline. The results demonstrate that an increased ratio of dispersed phase velocity to continuous phase velocity leads to a significant increase in the volume of generated droplets, a significant decrease in droplet generation frequency, and a significant decrease in droplet pressure at the centerline. Furthermore, as the viscosity of continuous phase increases, the volume of generated droplets decreases significantly, the frequency of droplet generation increases significantly, and the pressure of droplets at the centerline decreases significantly. Additionally, an elevated contact angle between the continuous phase and the wall results in a slight increase in the volume of generated droplets, alongside a reduction in droplet generation frequency and a decrease in droplet pressure at the centerline. Moreover, with the increase in interfacial tension, there is a significant increase in the volume of droplet generation, a significant decrease in the frequency of droplet generation, and a significant increase in the pressure of droplets at the centerline.

Numerical Simulation of Droplet Formation in Contact Micro-Liquid Dispensing

Numerical Simulation of Spray Flow Processes in Adjustable Centrifugal Nozzle

Simulation and Experiment on Droplet Formation and Separation for Needle-Type Micro-Liquid Jetting Dispenser

Numerical Simulation of Droplet Generation in Cross-Junction Microchannel under Changing Dispersion Phase Velocities

Numerical Analysis of the Impact of Two Droplets with a Liquid Film Using an Incompressible SPH Method

Numerical simulation of droplet formation in a Co-flow microchannel capillary device

Numerical Modelling for the Droplets Formation in Microfluidics - A Review

Numerical simulation of droplet dynamic behaviors in a convergent microchannel

Numerical Simulation of A Droplet Motion in A Grooved Microchannel

Numerical Simulation on Dynamics of a Droplet Upon a Liquid Film

Numerical Study On Liquid Droplet Formation In T-Junction Microchannel

3D simulation estimation and experimental validation of droplet generation in CFD-based flow-focusing microfluidic chips

Modeling of Early Stage Droplet Spreading Based on Numerical Simulations

Numerical Simulation on the Formation Process of Metal Droplets by Pneumatic Diaphragm Drop-on Demand Technology

Numerical Simulation of Motion and Distribution Characteristics for Electrospray Droplets

Numerical simulation of emulsion droplet formation in cross-j unction microfluidic channels

Experimental and Numerical Study on the Droplet Formation in A Cross-Flow Microchannel

Simulation and Experiment Research of Non-contact Micro-liquid Reagent Dispensing

Numerical Simulation of Water Droplets on Rough Surfaces

Numerical Investigation of Droplet Pre-Dispersion in a Monodisperse Droplet Spray Dryer

Research on Micro-Liquid Dispensing Driven by a Syringe Pump with the Consideration of Air Volume