Abstract:The new energy vehicle industry needs a large number of vehicle power batteries, and its production depends on high-speed and high-precision battery pole-piece cutting equipment, which is mainly composed of the electrode material roll uncoiling unit, buffering unit, main drive unit, and cutting unit. Due to the nonlinearity and high-speed intermittent motion mode of a servomotor, the existing control technology is difficult to apply to the cutting system. This article presents a multimotor linear velocity planning approach used to ensure synchronous and cooperative operation of the motors in the cutting system. To achieve fast and accurate positioning control of the main drive motor running in fast acceleration and deceleration, periodic and intermittent mode, an adaptive position controller based on data-driven modeling technique is proposed, which makes the parameters of the controller change with the operation state of the main drive motor so that the controller can obtain good positioning accuracy in a wide working range of the main drive motor. Two linear models are established to represent the relationship between the positioning error and the positioning controller parameters and the main drive motor running conditions. The parameters of the two models are estimated offline and the parameters of the adaptive position controller can be obtained online quickly. Thus, the proposed control method for the main drive motor can be easily realized by general PLC in practical application. Simulation study results show that using the proposed method, the positioning error of the main drive motor is less than 0.1mm when cutting 89-mm-long battery pole-piece and cutting 1 to 3 pieces/s. This result is much better than that of the position controller with fixed parameters.

Single Neuron PID Model Reference Adaptive Control for Filling Machine Based on DRNN Neural Network On-Line Identification

Single neuron predictive pid control

A Pid Controller With Neuron Tuning Parameters For Multi-Model Plants

Load Testing System Based on BP Neural Networks Self-adaptive PID Controller

Adaptive PID Control for Thrust Speed of Shield Based on Single Neuron

Neuron Controller With Adaptive Regulated Gain For Paper Machine

Nonlinear adaptive control based on RBF networks and multi-model method

An improved control strategy of single neuron PID

A Neuron Adaptive PID Speed and Position Control for Ultrasonic Motors

Neural Network Control Of Electric Vehicle Based On Position-Sensorless Brushless Dc Motor

Neuron Model-Free Pid Control

Online Reinforcement Learning Neural Network Controller Design for Nanomanipulation

Neural-Network-Based Predictive Control for PMSM Drives

Adaptive PID controller based on single neuron for permanent magnet synchronous machine

PID Adaptive Feedback Motor System Based on Neural Network

Deterministic Learning-Based Neural PID Control for Nonlinear Robotic Systems

Adaptive Positioning Control of Servomotor Based on Model Identification

Intelligent Backstepping Control of Permanent Magnet-Assisted Synchronous Reluctance Motor Position Servo Drive with Recurrent Wavelet Fuzzy Neural Network

Adaptive PI Controller for Speed Control of Electric Drives Based on Model Reference Adaptive Identification

Adaptive neural network control for permanent magnet synchronous motor with input nonlinearity

A Single Neuron PID Controller Based PMSM DTC Drive System Fed by Fault Tolerant 4-Switch 3-Phase Inverter