Abstract:Continuum manipulators have infinite degrees of freedom and high flexibility, making it challenging for accurate modeling and control. Some common modeling methods include mechanical modeling strategy, neural network strategy, constant curvature assumption, etc. However, the inverse kinematics of the mechanical modeling strategy is difficult to obtain while a strategy using neural networks may not converge in some applications. For algorithm implementation, the constant curvature assumption is used as the basis to design the controller. When the driving wire is tight, the linear controller under constant curvature assumption works well in manipulator position control. However, this assumption of linearity between the deformation angle and the driving input value breaks upon repeated use of the driving wires which get inevitably lengthened. This degrades the accuracy of the controller. In this work, the Koopman theory is used to identify the nonlinear model of the continuum manipulator. Under the linearized model, the control input is obtained through model predictive control (MPC). As the lifted function can affect the effectiveness of the Koopman operator-based MPC (K-MPC), a novel design method of the lifted function through the Legendre polynomial is proposed. To attain higher control efficiency and computational accuracy, we use a selective control scheme according to the state of the driving wires. When the driving wire is tight, the linear controller is employed; otherwise, the K-MPC is adopted. Finally, a set of static and dynamic experiments have been conducted using an experimental prototype. The results demonstrate high effectiveness and good performance of the selective control scheme.

Predictive Control for Multi-Joint Manipulator with Polytopic Model

Robust predictive control of constrained piecewise affine systems based on a contractive sequence of sets

Feedback-linearization-based Model Predictive Control for Multiple-DOFs Manipulators Via Logarithm Sliding Mode

An MPC-based Pose Control Framework of Multi-Section Soft Manipulator Using Hybrid Jacobian Estimation.

Stabilizing Model Predictive Control Strategy for Permanent Magnet Synchronous Motor with Multi-Variable Constraints

Nonlinear Model Predictive Control of Space Redundant Manipulators

Trajectory Tracking of Robotic Manipulators with Constraints Based on Model Predictive Control

A Hybrid Controller for a Soft Pneumatic Manipulator Based on Model Predictive Control and Iterative Learning Control

Robust Low Complexity Predictive Control of Constrained Piecewise Affine Systems with Bounded Disturbances

Robust Model Predictive Control for Two-DOF Flexible-Joint Manipulator System

A Robust Tube-Based Smooth-MPC for Robot Manipulator Planning

Model Prediction Based Adaptive Variable Impedance Control of Manipulator with Passivity

The Trajectory Planning Of 9 Degree-Of-Freedom Manipulator Based On Model Predictive Control Method

Model Predictive Control of Piecewise Affine System with Constrained Input and Time Delay

Robust Position Control of a Continuum Manipulator Based on Selective Approach and Koopman Operator

Multi-contact MPC for Dynamic Loco-manipulation on Humanoid Robots

Model Predictive Control For Position Tracking Of Robot Manipulator

Robust tube-based MPC with smooth computation for dexterous robot manipulation

Multi-Objective Robust Control of Flexible-Link Manipulators Based on Fuzzy Singularly Perturbed Model with Multiple Perturbation Parameters

A Multi-Step Robust Model Predictive Control Scheme for Polytopic Uncertain Multi-Input Systems

Model Predictive Control Of Piecewise Affine Systems With Constrained Input And Terminal Ellipsoid