Abstract:In the present study, multidimensional computational fluid dynamics (CFD) simulations were carried out to study mixture formation in a turbocharged port-injection natural gas engine. In order to achieve robust simulation results, multiple cycle simulation was employed to remove the inaccuracies of initial conditions setting. First, the minimal number of simulation cycles required to obtain convergent cycle-to-cycle results was determined. Based on this, the in-cylinder mixture preparation for three typical operating conditions was studied. The effects of fuel injection timing and intake valve open scheme on the mixture formation were evaluated. The results demonstrated that three simulation cycles are needed to achieve convergence of the results for the present study. The analysis of the mixture preparation revealed that only in the initial phase of the intake stroke, there is an obvious difference between the three operating conditions. At the spark timing, for 5500 rpm, full load condition mixture composition throughout the cylinder is flammable, and for 2000 rpm, 2 bar operating condition part of the mixture is lean and nonflammable. The fuel injection timing has an insignificant impact on the mixture flammability at the spark timing. It was observed that the designed nonsynchronous intake valve open scheme has stronger swirl and x-direction tumble motion than the baseline case, leading to better mixture homogeneity and spatial distribution. With an increase in volumetric efficiency, particularly at 2000 rpm, full load condition, by 4.85% compared to the baseline, which is in line with experimental observation.

Application of Numerical Simulation in Investigating Factors Effecting Torque Characteristics of Small Gasoline Engine

Study on exhaust system parameters for fuel economy improvement of small gasoline engine

Numerical Simulation on Operating Characteristics of Hybrid Compressed-air and Fuel Engine

Study on the Intake System Parameters of Small Gasoline Engine

Numerical computed methods for intake manifolds in gasoline engine

The Application of Cycle Simulation in the Variable Geometric Intake Design

Optimization of Gasoline Engine Intake System Based on 1D, 3D and Coupled Simulations

Effects of Valve Timing on Gasoline Engine Performance

Research on the Influence of the Intake System Parameters on Performance of Small Gasoline Engines

Numerical Simulation of Intake and Exhaust Process of Turbocharged Diesel Engine

Performance Analysis and Optimization of a 2.0L Gasoline Engine based on GT-Power Simulation

Influence of Different Mechanisms and Models on Numerical Simulation Results of Gas Turbine Combustors

Influence of Intake Phase on Part Load Performance for High Expansion Ratio Gasoline Engine

Study on Multi-Dimensional Numerical Simulation for Intake Process in Internal Combustion Engines

Numerical simulation of direct injection gasoline engine model

The effect of intake valve layout on intake process in gasoline engine

Numerical Simulation to the Influence of Injection Parameters on Gasoline Direct Injection

Design and Performance Simulation of Small-Scale Rotary Engine

Working Process of Optimization Performance of Turbocharged PFI Gasoline Engine by Numerical Simulation

Numerical Investigation on Mixture Formation in a Turbocharged Port-Injection Natural Gas Engine Using Multiple Cycle Simulation

A Numerical Simulation of the Working Process of Diesel Engine