Abstract:In this paper, optimum stress distribution for hollow plates composed of linear cellular materials (LCMs), a kind of truss-like material, is investigated. To reduce the computational cost, we model the material as micropolar continua representation. Two classes of design variables, relative density, and cell-size distribution of truss-like materials are to be determined by optimization under given total material volume constraint. And the concurrent designs of material and structure are obtained for three different optimization formulations. For the first formulation, we aim at the minimization of the maximum stress that appears at the initial uniform design; for the second formulation, we minimize the highest stress within the specified point set. As the yield strength of truss-like material is dependent on the relative material density, we minimize the ratio of stress over the corresponding yield strength along the hole boundary in our third formulation, which maximizes the strength reserve and seems more rational. The numerical results for the three objectives validate the concurrent optimization method proposed in this paper. And the influence of ply angle (angle between the principle direction of material and the axes of the system’s coordinates) on the optimum result is discussed. The dependence of optimum design on finite element meshes is also investigated. An approximate discrete model is established to verify the method proposed in this paper, and the stress concentration near a hole is reduced significantly.

Optimum Structure with Homogeneous Optimum Truss-like Material

Structure-Material concurrent optimization considering uniform material microstructure

A Uniform Optimum Material Based Model For Concurrent Optimization Of Thermoelastic Structures And Materials

A homogeneous optimum material based model for concurrent optimization of thermoelastic structures and materials

Topology Optimal Design of Material Microstructures Using Strain Energy-based Method

Layout Design of Thin-Walled Structures with Lattices and Stiffeners Using Multi-Material Topology Optimization

Concurrent Topological Design of Composite Thermoelastic Macrostructure and Microstructure with Multi-Phase Material for Maximum Stiffness

Non-probabilistic Reliability Based Topology Optimization Design of Two-material Structures

MULTIPLE OBJECTIVE TOPOLOGY OPTIMAL DESIGN OF MULTIPHASE MICROSTRUCTURES

Scale-span Stress-Constrained Topology Optimization for Continuum Structures Integrating Truss-Like Microstructures and Solid Material

Concurrent Material and Structural Optimization of Hollow Plate with Truss-Like Material

TOPOLOGY OPTIMIZATION OF STRUCTURES DESIGNED WITH MULTIPHASE MATERIALS: VOLUME CONSTRAINT OR MASS CONSTRAINT?

Maximal Stiffness Design of Two-Material Structures by Topology Optimization with Nonprobabilistic Reliability

Two-scale Concurrent Topology Optimization with Multiple Micro Materials Based on Principal Stress Orientation

A Solid Isotropic Material with Parallel Penalization Method for Structural Topology Optimization with Multiple Materials

Concurrent Topology Optimization Design of Structures and Non-Uniform Parameterized Lattice Microstructures

A novel reliability‐based topology optimization framework for the concurrent design of solid and truss‐like material structures with unknown‐but‐bounded uncertainties

Topology Optimization of Thermo-Elastic Structures with Multiple Materials under Mass Constraint

Topology Optimization Design of Multi-Scale Structures with Alterable Microstructural Length-Width Ratios

Topology Optimization of Material Microstructures Using Energy-Based Homogenization Method under Specified Initial Material Layout

Topology Optimization of Couple-Stress Material Structures