Mobile LiDAR Scanning System Combined with Canopy Morphology Extracting Methods for Tree Crown Parameters Evaluation in Orchards

Kai Wang,Jun Zhou,Wenhai Zhang,Baohua Zhang
DOI: https://doi.org/10.3390/s21020339
IF: 3.9
2021-01-06
Sensors
Abstract:To meet the demand for canopy morphological parameter measurements in orchards, a mobile scanning system is designed based on the 3D Simultaneous Localization and Mapping (SLAM) algorithm. The system uses a lightweight LiDAR-Inertial Measurement Unit (LiDAR-IMU) state estimator and a rotation-constrained optimization algorithm to reconstruct a point cloud map of the orchard. Then, Statistical Outlier Removal (SOR) filtering and European clustering algorithms are used to segment the orchard point cloud from which the ground information has been separated, and the k-nearest neighbour (KNN) search algorithm is used to restore the filtered point cloud. Finally, the height of the fruit trees and the volume of the canopy are obtained by the point cloud statistical method and the 3D alpha-shape algorithm. To verify the algorithm, tracked robots equipped with LIDAR and an IMU are used in a standardized orchard. Experiments show that the system in this paper can reconstruct the orchard point cloud environment with high accuracy and can obtain the point cloud information of all fruit trees in the orchard environment. The accuracy of point cloud-based segmentation of fruit trees in the orchard is 95.4%. The R2 and Root Mean Square Error (RMSE) values of crown height are 0.93682 and 0.04337, respectively, and the corresponding values of canopy volume are 0.8406 and 1.5738, respectively. In summary, this system achieves a good evaluation result of orchard crown information and has important application value in the intelligent measurement of fruit trees.
engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the need to measure the morphological parameters of fruit tree canopies in orchards efficiently and accurately. Traditional methods such as tape measure measurement and projection methods are time - consuming and labor - intensive, and the measurement accuracy depends on the proficiency of the operator. Although ground - based LiDAR (Light Detection and Ranging) technology has achieved a certain level of accuracy in canopy measurement, its cumbersome operation and high cost limit its popularization and application. In addition, the existing measurement methods based on the integration of the Global Navigation Satellite System (GNSS) and LiDAR are prone to signal loss and measurement failure problems under the high - density and high - height canopies in orchards. For this reason, this paper designs a mobile scanning system based on the 3D Simultaneous Localization and Mapping (SLAM) algorithm. This system uses a lightweight LiDAR - Inertial Measurement Unit (IMU) state estimator and a rotation - constraint optimization algorithm to reconstruct the point - cloud map of the orchard. The orchard point - cloud is segmented by Statistical Outlier Removal (SOR) filtering and Euclidean Clustering algorithms, and then the filtered point - cloud information is recovered by using the k - Nearest Neighbor (KNN) search algorithm. Finally, important morphological parameters such as the height and canopy volume of fruit trees are obtained through point - cloud statistical methods and the 3D alpha - shape algorithm. The experimental results show that this system can reconstruct the orchard point - cloud environment with high accuracy and obtain the point - cloud information of all fruit trees in the orchard environment. The \(R^2\) value of the canopy height is 0.93682, and the Root Mean Square Error (RMSE) is 0.04337; the corresponding values of the canopy volume are 0.8406 and 1.5738 respectively. In short, this system has important application value in the intelligent measurement of orchard canopy information.