Electrochemical degradation performance and mechanism of dibutyl phthalate with hydrophobic PbO2 electrode

Yongsheng Chen,Dexiang Liao,Yue Lin,Tianyu Deng,Fang Yin,Penghao Su,Daolun Feng
DOI: https://doi.org/10.1016/j.chemosphere.2021.132638
IF: 8.8
2022-02-01
Chemosphere
Abstract:A polytetrafluoroethylene (PTFE) doped PbO<sub>2</sub> anode with a highly hydrophobicity was fabricated by electrodeposition method. In this process, vertically aligned TiO<sub>2</sub> nanotubes (TiO<sub>2</sub>NTs) are formed by the anodic oxidation of Ti plates as an intermediate layer for PbO<sub>2</sub> electrodeposition. The characterization of the electrodes indicated that PTFE was successfully introduced to the electrode surface, the TiO<sub>2</sub>NTs were completely covered with β-PbO<sub>2</sub> particles and gave it a large surface area, which also limited the growth of its crystal particles. Compared with the conventional Ti/PbO<sub>2</sub> and Ti/TiO<sub>2</sub>NTs/PbO<sub>2</sub> electrode, the Ti/TiO<sub>2</sub>NTs/PbO<sub>2</sub>-PTFE electrode has enhanced surface hydrophobicity, higher oxygen evolution potential, lower electrochemical impedance, with more active sites, and generate more hydroxyl radicals (·OH), which were enhanced by the addition of PTFE nanoparticles. The electrocatalytic performance of the three electrodes were investigated using dibutyl phthalate (DBP) as the model pollutant. The efficiency of the DBP removal of the three electrodes was in the order: Ti/TiO<sub>2</sub>NTs/PbO<sub>2</sub>-PTFE &gt; Ti/TiO<sub>2</sub>NTs/PbO<sub>2</sub> &gt; Ti/PbO<sub>2</sub>. The degradation process followed the pseudo-first-order kinetic model well, with rate constants of 0.1326, 0.1266, and 0.1041 h<sup>-1</sup> for the three electrodes, respectively. The lowest energy consumption (6.1 kWh g<sup>-1</sup>) was obtained after 8 h of DBP treatment using Ti/TiO<sub>2</sub>NTs/PbO<sub>2</sub>-PTFE compared to Ti/TiO<sub>2</sub>NTs/PbO<sub>2</sub> (6.7 kWh g<sup>-1</sup>) and Ti/PbO<sub>2</sub> (7.4 kWh g<sup>-1</sup>) electrodes. Moreover, the effects of current density, initial pH and electrolyte concentration were investigated. Finally, the products of the DBP degradation process were verified based on gas chromatography-mass spectrometry analysis, and possible degradation pathways were described.
environmental sciences
What problem does this paper attempt to address?