Influence of Feedstock Powder Characteristics on the Response to Heat Treatment of Cold-Sprayed Copper Coatings

Ioannis Kotsakis,Dominique Poirier,Jason D. Giallonardo,Stephen Yue

DOI: https://doi.org/10.1007/s11666-024-01865-6

IF: 2.839

2024-11-17

Journal of Thermal Spray Technology

Abstract:The quality of cold-sprayed copper coatings in the as-sprayed condition heavily relies on the characteristics of the feedstock powder. While previous studies have delved into the influence of particle velocity, size and surface oxides on the quality of as-sprayed coatings, little attention has been paid to investigating the heat treatment responses of coatings with distinct initial characteristics. In previous work, the effects of particle velocity, size and surface oxides on as-sprayed coating properties (i.e., microstructural characteristics, mechanical properties and electrical conductivity) were investigated. Coatings with different as-sprayed quality were produced, ranked from "best" to "worst." The differences in properties were attributed to variations in the amounts of defects at the particle–particle interfaces (PPIs), caused by different process parameters (i.e., gas pressure) and powder characteristics (i.e., particle size) for each coating. The present study focuses on the subsequent heat treatment of these coatings under identical conditions (1 h at 350 °C, under ambient atmosphere), to monitor the evolution of their microstructural characteristics, mechanical and electrical properties. The results show that in all cases, the ductility and electrical conductivity of the coatings generally improved with heat treatment, compared to the as-sprayed condition. This is primarily attributed to the redistribution of interparticle oxides at the PPIs that improved the bonding between the particles. However, it is also indicated that the general belief that coatings that have superior properties in the as-sprayed condition will remain superior post-heat treatment is not necessarily true. It is shown that it is possible that coatings that originally had superior as-sprayed features may be surpassed by inferior ones, after heat treatment.

materials science, coatings & films