Abstract:Metal–polymer interface plays a crucial role in controlling the dielectric performance in all flexible electronics. Ideally, the formation of the Schottky barrier due to the large band offset of the electron affinity of the polymer over the work function of the electrode should sufficiently impede the charge injection. Arguably, however, such an injection barrier has hardly been indisputably verified in polymer–metal junctions due to the ever-existing surface states, which dramatically compromise the barrier thus leading to undesired high electrical conduction. Here, we demonstrate experimentally a clear negative correlation between the breakdown strength and the density of surface states in polymer dielectrics. The existence of surface states reduces the effective barrier height for charge injection, as further revealed by density functional theory calculations and photoinjection current measurements. Based on these findings, we present a surface engineering method to enhance the breakdown strength with the application of nanocoatings on polymer films to eliminate surface states. The density of surface states is reduced by 2 orders of magnitude when the polymer is coated with a layer of two-dimensional hexagonal boron nitride nanosheets, leading to about 100% enhancement of breakdown strength. This work reveals the critical role played by surface states on electrical breakdown and provides a versatile surface engineering strategy to curtail surface states, broadly applicable for all polymer dielectrics.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c12854.Molecular structures of polymer dielectrics in this study, illustration of the photocurrent setup, incident light beam spectrum for photocurrent test, photocurrents and barrier heights of polymer dielectrics with gold electrode and aluminum electrodes, band gaps of 2D nanocoating materials, and photocurrents and barrier heights of coated polymer dielectrics of polymer dielectrics with gold and aluminum electrodes (PDF)This article has not yet been cited by other publications.

Preventing partial discharge in liquid metal polymer composites under steep voltage pulses

Mitigating Partial Discharge Caused by Steep Voltage Pulses at High Temperatures

Physical passivation of deep-level defect states in polymer dielectrics for outstanding dielectric properties

Rapid Deformation of IPMC under a High Electrical Pulse Stimulus Inspired by Action Potential

Investigation of Surface Discharges on Different Polymeric Materials under Hvac in Atmospheric Air

Preparation of PANI/CuPc/PDMS Composite Elastomer with High Dielectric Constant and Low Modulus Assisted by Electric Fields

Field Plate Integration for Mitigating Partial Discharge Activity in PCB-Embedded Power Electronic Modules

Enhancing breakdown strength and lifetime of multilayer dielectric films by using high temperature polycarbonate skin layers

Partial discharge characteristics of oil/polypropylene film with a needle-plate electrode excited by impulse voltages

Investigation of Partial Discharge Transformation Characteristics in Polyimide (PI) Insulations under High-Frequency Electric Stress

Effects of Low Pressure Condition on Partial Discharges in WBG Power Electronics Modules

Suppressing the Loss of Polymer‐based Dielectrics for High Power Energy Storage

Safe and Negligible-Loss Overcurrent Protection: A Novel Macromolecular Voltage Stabilizer for Conductive Polymer Composites

Slow Current Induced by Partial Discharge in Kapton, Epoxy and PET

Study on the Effect of Electron/Hole Injection on the Energy-Storage Properties of Polymer Dielectrics

Excess conduction induced by partial discharge in polymer

Achieving High Performance Electric Field Induced Strain: A Rational Design of Hyperbranched Aromatic Polyamide Functionalized Graphene-Polyurethane Dielectric Elastomer Composites

Enhanced Energy Density at Low Operating Field Strength of Laminated Multicomponent Polymer-Based Composites Via Regulation of Electrical Displacement

Enabling Polymer Single Crystals to Be High‐Performance Dielectric

Surface Damage of Polymer Dielectric under Repetitive Frequency Bipolar Square-Wave Voltage

Tuning Surface States of Metal/Polymer Contacts Toward Highly Insulating Polymer-Based Dielectrics