Abstract:Ideal transmitting and receiving (Tx/Rx) array response is always desirable in multiple-input multiple-output (MIMO) radar. In practice, nevertheless, Tx/Rx arrays may be susceptible to unknown gain-phase errors (GPE) and yield seriously decreased positioning accuracy. This paper focuses on the direction-of-departure (DOD) and direction-of-arrival (DOA) problem in bistatic MIMO radar with unknown gain-phase errors (GPE). A novel parallel factor (PARAFAC) estimator is proposed. The factor matrices containing DOD and DOA are firstly obtained via PARAFAC decomposition. One DOD-DOA pair estimation is then accomplished from the spectrum searching. Thereafter, the remainder DOD and DOA are achieved by the least squares technique with the previous estimated angle pair. The proposed estimator is analyzed in detail. It only requires one instrumental Tx/Rx sensor, and it outperforms the state-of-the-art algorithms. Numerical simulations verify the theoretical advantages.
environmental sciences,imaging science & photographic technology,remote sensing,geosciences, multidisciplinary
What problem does this paper attempt to address?
The problem that this paper attempts to solve is how to accurately estimate the Direction - of - Departure (DOD) and Direction - of - Arrival (DOA) in a bistatic Multiple - Input Multiple - Output (MIMO) radar system in the presence of Gain - Phase Errors (GPE). Specifically, the paper focuses on how to effectively solve this problem when there is only one calibrated transceiver sensor.
### Background and Challenges
In practical applications, due to hardware non - idealities, the transceiver arrays of MIMO radars may be affected by unknown gain - phase errors, which will cause perturbations in the direction matrix and further reduce the positioning accuracy. Traditional algorithms usually assume that the sensor responses are ideal, that is, the transceiver sensors are well - calibrated. However, in practical applications, this assumption is often not valid, so new methods need to be developed to deal with gain - phase errors.
### Main Contributions of the Paper
1. **Adapt to a Single Calibrated Sensor**: Different from the existing frameworks, the estimation algorithm proposed in this paper is applicable to MIMO radar systems with only a single calibrated transceiver sensor. This improvement is due to the fact that the algorithm takes into account the random characteristics of phase errors and can adapt to any transceiver sensor geometry.
2. **High Computational Efficiency**: The estimation of DOD and DOA can be completed by a combination of one - dimensional grid search and Least Squares (LS) fitting, without the need for eigenvalue decomposition or high - dimensional spectral search.
### Method Overview
1. **Model Establishment**: The paper first establishes a MIMO radar signal model that includes gain - phase errors. Specifically, the received signal can be expressed as:
\[
x(\tau)=\sum_{k = 1}^{K}[(C_r a_r(\theta_k)\otimes C_t a_t(\phi_k))]b_k(\tau)+n(\tau)
\]
where \(C_t\) and \(C_r\) represent the gain - phase error matrices of the transmitting and receiving arrays respectively, \(a_t(\phi_k)\) and \(a_r(\theta_k)\) represent the transmitting and receiving direction vectors respectively, \(b_k(\tau)\) represents the complex envelope of the \(k\) - th target, and \(n(\tau)\) represents the noise.
2. **PARAFAC Decomposition**: Through PARAFAC decomposition, the perturbed direction matrix can be extracted from the data. Specifically, the optimization problem can be expressed as:
\[
\min_{\tilde{A}_t,\tilde{A}_r,B}\|\mathcal{X}-\mathcal{I}\times_1\tilde{A}_r\times_2\tilde{A}_t\times_3B\|_F
\]
where \(\mathcal{X}\) is the third - order tensor representation of the observed data, and \(\mathcal{I}\) is the unit tensor.
3. **DOD and DOA Estimation**: Through one - dimensional grid search and least - squares fitting, DOD and DOA are estimated from the direction matrix obtained by PARAFAC decomposition. The specific steps include:
- Use the TALS technique to update the direction matrix and the reflection coefficient matrix.
- Find the first DOD through one - dimensional grid search.
- Use least - squares fitting to estimate the remaining DOD and DOA.
### Experimental Results
The paper verifies the effectiveness of the proposed algorithm through Monte Carlo simulations. The experimental results show that, compared with the existing ESPRIT - like, RD - MUSIC and PARAFAC - like algorithms, the proposed algorithm can still maintain high estimation accuracy at low signal - to - noise ratios and has higher computational efficiency.
### Conclusion
This paper proposes a DOD and DOA estimation algorithm based on PARAFAC decomposition, which can effectively improve the positioning accuracy of MIMO radar systems in the presence of gain - phase errors and with only one calibrated transceiver sensor. This algorithm is not only computationally efficient, but also insensitive to gain errors, but is sensitive to phase...