Effects of Pyrolysis Temperature and Acid-Base Pre-Treatment on the Synthesis of Biochar-Based Slow-Release Selenium Fertilizer and Its Release in Soil

Jun Chu,Suikai Wang,Jie Yu,Yuting Gao,Zhenya Tang,Qiliang Yang

DOI: https://doi.org/10.3390/ma17040879

IF: 3.4

2024-02-15

Materials

Abstract:Plant-derived selenium is an important source of selenium (Se) for humans, which, however, has been restricted by a low content of Se in soil. Traditional Se fertilizers have tended to result in low selenium utilization. Thus, it was necessary to develop a new slow-release material to control Se fertilizer release. In this study, biochar pyrolyzed at 300 °C and 800 °C was cross-linked with polyethyleneimine (PEI) after being treated with HNO3 or NaOH (which were labeled Acid-W300, Acid-W800, Alkali-W300, and Alkali-W800). The results showed that the maximum adsorption capacities of Acid-W300, Alkali-W300, Acid-W800, and Alkali-W800 were 329.16 mg/g, 321.93 mg/g, 315.04 mg/g, and 344.33 mg/g, respectively. Among them, Acid-W800 and Alkali-W800 were mainly imine- and amide-bonded with SO32−, while Acid-W300 and Alkali-W300 were loaded with SO32− by forming the C–Se bonding as well as through imine- and amide-bonding. The release of four biochar-based selenium fertilizers in the red soil and brown soil extracts conformed to the pseudo-second-order kinetic model. The release rate and release amount of four biochar-based selenium fertilizers in the red soil extract were higher than those in the brown soil extract. Alkali-W800-Se had a higher proportion of Se-exchangeable release, accounting for 87.5% of the total loaded selenium, while Acid-W300-Se had the lowest proportion at 62.2%. However, the Se releases of Alkali-W800-Se were more than 42.49% and 37.67% of the total Se-loading capacity during 5 days of continuous red soil extraction and brown soil extraction, respectively. Acid-W300-Se released less than 20% of the total Se-loading capacity. Thus, Acid-W300-Se was the recommended slow-release Se fertilizer in red soil and brown soil.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

The paper mainly explores the synthesis of biochar-based slow-release selenium fertilizers and their release characteristics in soil. The aim of the study is to develop a new type of slow-release material to control the release of selenium fertilizers, thereby improving the utilization rate of selenium in soil.

Specifically, the researchers produced biochar through pyrolysis at different temperatures (300°C and 800°C), pretreated it with either nitric acid (HNO3) or sodium hydroxide (NaOH), and then cross-linked it with polyethyleneimine (PEI) to prepare four types of modified biochar. These four types of modified biochar are labeled as Acid-W300, Alkali-W300, Acid-W800, and Alkali-W800. The experimental results show that these modified biochars have a high selenium adsorption capacity, and their selenium release in red soil and brown soil extracts follows a pseudo-second-order kinetic model. Among them, Alkali-W800 has a higher proportion of exchangeable selenium release, while Acid-W300 has a lower selenium release amount. Therefore, Acid-W300 is recommended as a slow-release selenium fertilizer in red soil and brown soil.

In summary, this paper aims to address the issue of low selenium content in soil by developing effective slow-release selenium fertilizers to enhance the absorption and utilization of selenium by plants, thereby improving the intake of selenium by humans through food.