One-pot molten-salt construction of channels for hole transport and mass transfer over CoS2 nanocubes for visible-light-driven CO2 reduction

Fulin Wang,Man Zhou,Weiya Huang,Kangqiang Lu,Shaobo Ouyang,Wentao Xiang,Chensheng Zhou,Changlin Yu,Kai Yang
DOI: https://doi.org/10.1039/d4qi00925h
IF: 7.779
2024-06-12
Inorganic Chemistry Frontiers
Abstract:The photocatalytic reduction of CO 2 into value-added chemicals is of great significance for the utilization of carbon resources, but it also faces the problem of low solar energy efficiency and inefficient charge separation. Herein, a CuSCN-loaded CoS 2 photocatalyst was prepared via a one-pot molten-salt method, and the optimal CO generation rate could reach 289.8 μmol g −1 h −1 (selectivity 92.0%), approximately 32 times that of bare CoS 2 under a visible-light excitation of λ ≥ 420 nm. In situ X-ray photoelectron spectroscopy (XPS) results indicate that CuSCN acts as a hole acceptor, and photoelectrochemical tests and density functional theory (DFT) calculations demonstrate that CuSCN/CoS 2 has higher efficiency in the separation and transfer of photogenerated carriers than CoS 2 . CuSCN was proved to be a strong carrier for CO 2 mass transfer through Brunauer–Emmett–Teller (BET) physical adsorption. Mechanistic studies show that CuSCN/CoS 2 is more conducive to the conversion of adsorbed CO 2 into the key reactive intermediate *COOH, for which the Co sites of CuSCN/CoS 2 exhibit a lower formation energy, in comparison with CoS 2 and CuSCN alone. As such, the combined action of CuSCN/CoS 2 was a synergistic effect that enhances CO 2 chemisorption and hole transfer, resulting in increased photocatalytic activity for CO 2 reduction.
chemistry, inorganic & nuclear
What problem does this paper attempt to address?