Reconfigurable synthetic dimension frequency lattices in an integrated lithium niobate ring cavity

Hiep X. Dinh,Armandas Balčytis,Tomoki Ozawa,Yasutomo Ota,Guanghui Ren,Toshihiko Baba,Satoshi Iwamoto,Arnan Mitchell,Thach G. Nguyen
DOI: https://doi.org/10.1038/s42005-024-01676-9
2024-06-12
Communications Physics
Abstract:Harnessing non-spatial properties of photons as if they represent an additional independent coordinate underpins the emerging synthetic dimension approach. It enables probing of higher-dimensional physical models within low-dimensional devices, such as on a planar chip where this method is relatively nascent. We demonstrate an integrated thin-film lithium niobate ring resonator that, under dynamic modulation, simulates a tight-binding model with its discrete frequency modes representing lattice sites. Inter-mode coupling, and the simulated lattice geometry, can be reconfigured by controlling the modulating signals. Up to a quasi-3D lattice connectivity with controllable gauge potentials has been achieved by simultaneous synchronized nearest-, second- and third-nearest-neighbor coupling, and verified by acquiring synthetic band structures. Development of synthetic frequency dimension devices in the thin-film lithium niobate photonic integration platform is a key step in increasing the complexity of topological models achievable on a chip, combining efficient electro-optic mode coupling with non-linear effects for long-range mode interactions.
physics, multidisciplinary
What problem does this paper attempt to address?
This paper attempts to solve the problem of how to simulate high - dimensional physical models on low - dimensional devices by realizing a reconfigurable synthetic frequency - dimensional lattice in an integrated lithium niobate thin - film ring cavity. Specifically, the paper shows how to use dynamic modulation techniques to represent lattice sites by discrete frequency modes in an integrated lithium niobate thin - film ring resonator to achieve the simulation of the tight - binding model. In addition, the paper also explores the possibility of reconfiguring the inter - mode coupling and simulating the lattice geometry by controlling the modulation signal. ### Main research questions 1. **Simulating high - dimensional physical models on low - dimensional devices**: - The paper explores how to use photons with non - spatial properties as additional independent coordinates, thereby simulating higher - dimensional physical models on low - dimensional devices (such as planar chips). - By implementing dynamic modulation in an integrated lithium niobate thin - film ring cavity, a tight - binding model is simulated, where discrete frequency modes represent lattice sites. 2. **Realizing a reconfigurable synthetic frequency - dimensional lattice**: - The paper shows how to reconfigure the inter - mode coupling and simulate the lattice geometry by controlling the modulation signal. - By simultaneously synchronizing the nearest - neighbor, next - nearest - neighbor, and third - nearest - neighbor couplings, a quasi - three - dimensional lattice connection is achieved, and the synthetic band structure is verified. 3. **Exploring the complexity of synthetic frequency - dimensional devices**: - The paper discusses the key steps in developing synthetic frequency - dimensional devices on the lithium niobate thin - film photon - integrated platform, combining efficient electro - optic mode coupling and nonlinear effects to achieve more complex topological models. - By controlling the relative phase of the modulation signal, a higher degree of control over the synthetic frequency - dimensional band structure is achieved, including inducing non - reciprocity and photon - gauge potential. ### Specific implementation methods - **Device design**: - Use an integrated lithium niobate thin - film racetrack resonator equipped with a broadband traveling - wave electro - optic modulator. - The free spectral range (FSR) of the resonator is 9.52 GHz, and the frequency - dimensional lattice is simulated by driving the device with a radio - frequency (RF) signal. - **Experimental characterization**: - The optical transmission spectrum of the resonator is measured experimentally to verify the performance of the device. - The dynamic behavior of the modulated ring cavity is revealed by time - resolved spectral transmission measurements. - **Band - structure measurement**: - The synthetic frequency - dimensional band structures at different modulation frequencies are measured experimentally to verify the accuracy of the theoretical model. - By adjusting the relative phase of the modulation signal, the control of the photon - gauge potential analogous to the synthetic magnetic field is achieved. ### Conclusion The paper successfully realizes a reconfigurable synthetic frequency - dimensional lattice in an integrated lithium niobate thin - film ring cavity, demonstrating the potential for simulating high - dimensional physical models on low - dimensional devices. By controlling the modulation signal, various complex lattice structures and band structures can be realized, providing new tools and methods for future photonics research.