Abstract:The trend related to reach the high operating temperature condition (HOT, temperature, T > 190 K) achieved by thermoelectric (TE) coolers has been observed in infrared (IR) technology recently. That is directly related to the attempts to reduce the IR detector size, weight, and power dissipation (SWaP) conditions. The room temperature avalanche photodiodes technology is well developed in short IR range (SWIR) while devices operating in mid-wavelength (MWIR) and long-wavelength (LWIR) require cooling to suppress dark current due to the low energy bandgap. The paper presents research on the potential application of the HgCdTe (100) oriented and HgCdTe (111)B heterostructures grown by metal-organic chemical vapor deposition (MOCVD) on GaAs substrates for the design of avalanche photodiodes (APDs) operating in the IR range up to 8 µm and under 2-stage TE cooling (T = 230 K). While HgCdTe band structure with molar composition xCd < 0.5 provides a very favorable hole-to-electron ionization coefficient ratio under avalanche conditions, resulting in increased gain without generating excess noise, the low level of background doping concentration and a low number of defects in the active layer is also required. HgCdTe (100) oriented layers exhibit better crystalline quality than HgCdTe (111)B grown on GaAs substrates, low dislocation density, and reduction of residual defects which contribute to a background doping within the range ~1014 cm-3. The fitting to the experimentally measured dark currents (at T = 230 K) of the N+-ν-p-P+ photodiodes commonly used as an APDs structure allowed to determine the material parameters. Experimentally extracted the mid-bandgap trap concentrations at the level of 2.5 × 1014 cm-3 and 1 × 1015 cm-3 for HgCdTe (100) and HgCdTe (111)B photodiode are reported respectively. HgCdTe (100) is better to provide high resistance, and consequently sufficient strength and uniform electric field distribution, as well as to avoid the tunneling current contribution at higher bias, which is a key issue in the proper operation of avalanche photodiodes. It was presented that HgCdTe (100) based N+-ν-p-P+ gain, M > 100 could be reached for reverse voltage > 5 V and excess noise factor F(M) assumes: 2.25 (active layer, xCd = 0.22, k = 0.04, M = 10) for λcut-off = 8 μm and T = 230 K. In addition the 4-TE cooled, 8 μm APDs performance was compared to the state-of-the-art for SWIR and MWIR APDs based mainly on III-V and HgCdTe materials (T = 77-300 K).

All-dielectric grating-assisted absorption enhancement in a subwavelength mercury cadmium telluride layer for infrared photodetectors

New resonant cavity-enhanced absorber structures for mid-infrared detector application

Low-Noise Te/MoTe2 Heterojunction Waveguide-Integrated Photodetector

Enhanced Light–Tellurium Interaction Through Evanescent Wave Coupling for High Speed Mid‐Infrared Photodetection

Van der Waals Epitaxial Growth of Mosaic‐Like 2D Platinum Ditelluride Layers for Room‐Temperature Mid‐Infrared Photodetection up to 10.6 μm

HgCdTe/CdTe/Si infrared photodetectors grown by MBE for near-room temperature operation

Mid-infrared plasmonic silicon quantum dot/HgCdTe photodetector with ultrahigh specific detectivity

CdTe Microwires As Mid-Infrared Optical Waveguides

Enhancing detectivity in mid-infrared photodetectors through structural parameter engineering in HgSe-HgTe colloidal quantum dots

Fast Uncooled Mid‐Wavelength Infrared Photodetectors with Heterostructures of van der Waals on Epitaxial HgCdTe

Upmost efficiency, few-micron-sized midwave infrared HgCdTe photodetectors

Design of Broadband Infrared Photodetectors Enhanced by Dual-Mode Plasmonic Resonant Cavities

Fabrication of 2D PdSe2/3D CdTe Mixed-Dimensional van der Waals Heterojunction for Broadband Infrared Detection

Mercury Chalcogenide Colloidal Quantum Dots for Infrared Photodetectors

Experimental Determination of the Dependence Between Spectral Response and Current–Voltage Characteristics for MWIR HgCdTe Detectors

Metal–Semiconductor-Metal Structure Enhanced Quantum Dot Infrared Photodetector for Near-Infrared

Design of Midinfrared Photodetectors Enhanced by Resonant Cavities with Subwavelength Metallic Gratings

Study of HgCdTe (100) and HgCdTe (111)B Heterostructures Grown by MOCVD and Their Potential Application to APDs Operating in the IR Range up to 8 µm

Bi 2 S 3 Electron Transport Layer Incorporation for High-Performance Heterostructure HgTe Colloidal Quantum Dot Infrared Photodetectors

Guided CdTe Nanowires Integrated into Fast Near-Infrared Photodetectors

Two-dimensional molybdenum ditelluride waveguide-integrated near-infrared photodetector