Abstract:BACKGROUND: In development of inhaled drugs- and formulations the measured concentration in the systemic circulation is often used as a surrogate for local dosimetry in the lungs. To further elucidate regional differences in the fate of drugs in the lungs, different aerodynamic sizes of aerosols have been used to target major airway regions. An alternative approach to achieve regional targeting of aerosols, is to use a defined aerosol bolus together with a bolus breath hold strategy. A small volume of test aerosol is intercalated and stopped at different penetration depths, to achieve increased drug deposition at chosen lung locations. Drug permeation from the lung regions is then investigated by repeatedly sampling venous blood from the systemic circulation. The PreciseInhale® (PI) exposure platform was developed to allow generation of aerosols from different sources, including clinical inhalers, into a holding chamber, for subsequent use with alternative exposure modules in vitro and in vivo. In the current first-in-human study was investigated the feasibility of a new clinical exposure module added to the PI system. By extracting aerosol puffs from a medical inhaler for subsequent delivery to volunteers, it was possible to administer whole lung exposures, as well as regional targeting exposures.METHODS: Aerosols containing 250 µg/25 µg fluticasone propionate (FP)/salmeterol xinafoate (SMX) were automatically actuated and extracted from the pressurized Metered Dose Inhaler (pMDI) Evohaler Seretide forte into the PI system's holding chamber, then administered to the healthy volunteers using controlled flowrate and volume exposure cycles. Two main comparisons were made by measuring the systemic PK response: I. One label dose directly from the inhaler to the subject was compared to the same dose extracted from the pMDI into the PI system and then administered to the subject. II A small aerosol bolus at a penetration level in the central airways was compared to a small aerosol bolus at a penetration level in the peripheral lung.RESULTS AND CONCLUSIONS: When one inhaler dose was administered via the PI system, the absorbed dose, expressed as AUC24, was approximately twice as high and the CV was less than half, compared to direct inhalation from the same pMDI. Bolus breath hold targeting of drugs from the same aerosol mixture to the peripheral lung and the central airways showed a difference in their appearance in the systemic circulation. Normalized to the same deposited dose, SMX had a 57 % higher Cmax in the peripheral lung compared to the central airways. However, from 6 to 24 h after dosing the systemic concentrations of SMX from both regions were quite similar. FP had parallel concentrations curves with a 23 % higher AUC24 in the peripheral lung with no noticeable elevation around Cmax. The permeability of these two substances from similar sized aerosols was indeed higher in the thinner air/blood barriers of the peripheral lung compared to the central airways, but differences as measured on the venous side of the circulation were not dramatic. In conclusion, the PI system provided better control of actuation, aspiration, and dispensation of aerosols from the clinical inhaler and thereby delivered higher quality read outs of pharmacokinetic parameters such as tmax, Cmax, and AUC. Improved performance, using PI system, can likely also be employed for studying regional selectivity of other responses in the lungs, for use in drug development.

Inter-patient variability of inhaled medication lung deposition using Functional Respiratory Imaging (FRI)

Predicting Lung Deposition of Extrafine Inhaled Corticosteroid-Containing Fixed Combinations in Patients with Chronic Obstructive Pulmonary Disease Using Functional Respiratory Imaging: An In Silico Study

Modeled small airways lung deposition of two fixed-dose triple therapy combinations assessed with in silico functional respiratory imaging

Models of deposition, pharmacokinetics, and intersubject variability in respiratory drug delivery

In Vitro Analysis of Aerodynamic Properties and Co-Deposition of a Fixed-Dose Combination of Fluticasone Furoate, Umeclidinium Bromide, and Vilanterol Trifenatate

Variability of fine particle dose and lung deposition of budesonide delivered through two multidose dry powder inhalers

Rapid deposition analysis of inhaled aerosols in human airways

Predicting in vitro lung deposition behavior of combined dry powder inhaler via rheological properties

In vitro dose comparison of Respimat® inhaler with dry powder inhalers for COPD maintenance therapy

In Silico Study on the Deposition and Distribution of Particles in a Realistic Airway Model with Handilaher®

Numerical study on the deposition distribution and mechanism of inhaled drug particles in various regions of the realistic inhaler-airway model

Functional respiratory imaging assessment of budesonide/glycopyrrolate/formoterol fumarate and glycopyrrolate/formoterol fumarate metered dose inhalers in patients with COPD: the value of inhaled corticosteroids

Regional lung targeting with a fluticasone/salmeterol aerosol using a bolus breath hold method of the PreciseInhale® system: A first evaluation in humans

Pharmacokinetic Models for Inhaled Fluticasone Propionate and Salmeterol Xinafoate to Quantify Batch-to-Batch Variability

Median mass aerodynamic diameter (MMAD) and fine particle fraction (FPF): Influence on lung deposition?

Daily inhaled flow profiles and drug release from dry powder inhalers in patients with bronchial asthma

(FEV3-FEV1)/FVC: a Terminal-Airflow Variable for Airway Hyperresponsiveness and Inflammation Prediction in Patients with Symptoms Despite Preserved Spirometry

Regional Aerosol Deposition in the Human Airways: the SimInhale Benchmark Case and a Critical Assessment of in Silico Methods

Measuring Anatomical Distributions of Ventilation and Aerosol Deposition with PET-CT

Aerosol Deposition in Health and Disease

An individualised 3D computational flow and particle model to predict the deposition of inhaled medicines - A case study using a nebuliser