Abstract:The development of electrocatalysts with high catalytic activity is conducive to enhancing polysulfides adsorption and reducing activation energy of polysulfides conversion, which can effectively reduce polysulfide shuttling in Li-S batteries. Herein, a novel catalyst NiCo-MoO x /rGO (rGO = reduced graphene oxides) with ultra-nanometer scale and high dispersity is derived from the Anderson-type polyoxometalate precursors, which are electrostatically assembled on the multilayer rGO. The catalyst material possesses dual active sites, in which Ni-doped MoO x exhibits strong polysulfide anchoring ability, while Co-doped MoO x facilitates the polysulfides conversion reaction kinetics, thus breaking the Sabatier effect in the conventional electrocatalytic process. In addition, the prepared NiCo-MoO x /rGO modified PP separator (NiCo-MoO x /rGO@PP) can serve as a physical barrier to further inhibit the polysulfide shuttling effect and realize the rapid Li + migration. The results demonstrate that Li-S coin cell with NiCo-MoO x /rGO@PP separator shows excellent cycling performance with the discharge capacity of 680 mAh·g −1 after 600 cycles at 1 C and the capacity fading of 0.064% per cycle. The rate performance is also impressive with the remained capacity of 640 mAh·g −1 after 200 cycles even at 4 C. When the sulfur loading is 4.0 mg·cm −2 and electrolyte volume/sulfur mass ratio (E/S) ratio is 6.0 μL·mg −1 , a specific capacity of 830 mAh·g −1 is achieved after 200 cycles with a capacity decay of 0.049% per cycle. More importantly, the cell with NiCo-MoO x /rGO@PP separator exhibits cycling performance under wide operating temperature with the reversible capacities of 518, 715, and 915 mAh·g −1 after 100 cycles at −20, 0, and 60 °C, respectively. This study provides a new design approach of highly efficient catalysts for sulfur conversion reaction in Li-S batteries.

Favorable Moderate Adsorption of Polysulfide on FeNi3 Intermetallic Compound Accelerating Conversion Kinetics for Advanced Lithium–Sulfur Batteries

Three-Dimensional Ordered Fevo4 Nanocatalyst-Modified Separator Enables Suppressed Polysulfides Shuttling and Boosted Redox Conversion in Li-S Batteries

Selective Adsorption and Electrocatalysis of Polysulfides Through Hexatomic Nickel Clusters Embedded in N-Doped Graphene Toward High-Performance Li-S Batteries

Dual Active Sites of Oversaturated Fe-N5 and Fe2O3 Nanoparticles for Accelerating Redox Kinetics of Polysulfides

Expediting polysulfide catalytic conversion for lithium-sulfur batteries <i>via in situ</i> implanted ultrafine Fe<sub>3</sub>O<sub>4</sub> nanocrystals in carbon nanospheres

Hypercrosslinked Polymerization Enabled N‐Doped Carbon Confined Fe 2 O 3 Facilitating Li Polysulfides Interface Conversion for Li–S Batteries

Enhanced Catalytic Conversion of Polysulfides Using Bimetallic Co7Fe3 for High-Performance Lithium-Sulfur Batteries

Bimetallic sulfides heterostructure efficient adsorption and catalytic of polysulfides for high-performance lithium-sulfur batteries

Synergistic catalytic conversion and chemisorption of polysulfides from Fe/Fe 3 C/FeN 0.0324 nanocubes modified separator for advanced Li-S batteries

Intergrated morphology engineering and alloying strategy for FeNi@NC Catalysts: Tackling the polysulfide shuttle in Li-S batteries

Anchoring Polysulfides and Accelerating Redox Reaction Enabled by Fe‐Based Compounds in Lithium–Sulfur Batteries

Accelerating catalytic conversion and chemisorption of polysulfides for advanced Li-S batteries from incorporating Fe0.64Ni0.36@Co5.47N hetero-nanocrystals into boron carbonitride nanotubes

Amorphous Bimetallic-Organic Framework Enable Accelerated Redox Kinetics and Polysulfide Trapping for Lithium-Sulfur Batteries

Regulating the catalytic behaviour of iron oxyhydroxide by introducing Ni sites for facilitating polysulfide anchoring and conversion

Rational Design of a Ni3N0.85 Electrocatalyst to Accelerate Polysulfide Conversion in Lithium-Sulfur Batteries

Facilitation polysulfides adsorption/catalysis by nitrogen/phosphorous co-doped carbon nanofibers networks for advanced lithium/polysulfides batteries

Defects-Rich Single Atom Catalyst Enhanced Polysulfide Conversion Kinetics for Upgrading Performance of Li-S Batteries

Accelerated Polysulfide Conversion by Rationally Designed NiS2‐CoS2 Heterostructure in Lithium–Sulfur Batteries

NiCo2O4/CNF Separator Modifiers for Trapping and Catalyzing Polysulfides for High-Performance Lithium–Sulfur Batteries with High Sulfur Loadings and Lean Electrolytes

Modified separators boost polysulfides adsorption-catalysis in lithium-sulfur batteries from Ni@Co hetero-nanocrystals into CNT-porous carbon dual frameworks

Polysulfides adsorption and catalysis dual-sites on metal-doped molybdenum oxide nanoclusters for Li-S batteries with wide operating temperature