Abstract:Abstract Drainage capillary-pressure functions of reservoir rock-fluid-fluid systems are usually obtained by determining mercury-air capillary-pressure functions on the rock material and subsequently transforming the functions into those of the relevant systems. This procedure is followed because mercury-air capillary pressures can be measured rapidly and easily. The question arises whether this indirect procedure gives the same results as direct procedure gives the same results as direct measurements on the system in question. To investigate ibis, drainage capillary-pressure functions have been determined on the same rock material with various fluid-fluid combinations, including mercury-air. The measurements have been carried out by the semipermeable-membrane method under carefully controlled conditions. It appeared that with the aid of the measured interfacial tension, permeabilities, antiporosities, the capillary-pressure permeabilities, antiporosities, the capillary-pressure measurements could be transformed into one dimensionless capillary-pressure function without large discrepancies. Thus, the indirect method can indeed be applied in obtaining reasonably accurate results for the systems considered. The mercury-air interfacial tension of the mercury used in the experiments bas been found to be time-dependent as measured by the pendent-drop method. After a certain aging time of the drop, the interracial tension reaches an almost constant value and it is this value that must be used in the transformations. Additional measurements of drainage capillary-pressure functions for the rock-gas-oil system in the presence of connate water show that at sufficiently high gas-oil capillary-pressures, very low residual-oil saturations are obtained, irrespective of whether or not the oil phase spreads on water in the presence of gas. Low oil saturations are also obtained in gravity-drainage experiments after long drainage times when the capillary pressure is sufficiently high, possibly as a result pressure is sufficiently high, possibly as a result of oil "film flow." The contribution to oil production from film flow in secondary gas caps is production from film flow in secondary gas caps is thought to be generally negligible during the lifetime of a reservoir. In primary gas caps, however, where film flow may have occurred during geologic time spans, very low oil saturations may occur. Introduction The efficiency of oil recovery in the gas- and water-invaded zones of an oil reservoir is, apart from other properties, affected by the capillary properties of the rock-gas-oil and rock-water-oil properties of the rock-gas-oil and rock-water-oil systems present. Particularly in highly fractured oil reservoirs, being composed of a multitude of separated matrix blocks, the ultimate recoveries in gas- and water-invaded regions depend strongly on the capillary entrapments. Capillary properties are generally characterized by capillary-pressure functions. Those functions relate the capillary pressure - i.e., the pressure difference between two fluids present in the reservoir rock and the saturation of the rock by those two fluids. The functions depend on the way the saturations have been reached, a phenomenon known as capillary hysteresis. When the wetting-fluid saturation decreases monotonically from initially complete saturation, the function is called the "drainage capillary-pressure function"; when it increases monotonically from its irreducible saturation, the function is called "the imbibition capillary-pressure function." Between these two extremes many other capillary-pressure functions exist, depending on the initial value and change (not necessarily monotonic) of the wetting-fluid saturation. Capillary-pressure functions can be determined directly on the system in question, for instance by the time-consuming semipermeable-membrane method' or a centrifuge method, or indirectly with another fluid-fluid combination on the same rock material (for instance, by Purcell's rapid mercury-injection method), The functions obtained by the latter method must be transformed to those of the relevant system.

Criteria for displacement by gas versus water in oil reservoirs

Multi-dimensional Experimental Study of Hydrocarbon Gas-Assisted Gravity Drainage

Experimental Characterization of Oil/Gas Interface Self-Adjustment in CO2-Assisted Gravity Drainage for Reverse Rhythm Reservoir

Gravity effects on oil–water two-phase displacement in homogeneous porous media

Water-Gas Imbibition Relative Permeability: Literature Review, Direct versus Indirect Methods and Experimental Recommendations

Physical Simulation of Gas Injection Mechanism for High Dip Reservoir

Experimental Study on Sweep Characteristics of Gas Gravity Drainage in the Interlayer Oil Reservoir

Establishment of Stability Evaluation Criteria for the Oil–Gas Interface during Gas-Cap Gravity Flooding in Oil Reservoirs with Strong Edge-Water Drive

Dynamics of Water Injection in an Oil-Wet Reservoir Rock at Subsurface Conditions: Invasion Patterns and Pore-Filling Events

The effect of gas injection velocity and pore morphology on displacement mechanisms in porous media based on CFD approach

Study on flooding displacement based on the influence of fluid gravity differentiation

Influence of Gas Injection Parameters on the Effect of Unstable-state Displacement by Gas Flooding

Drainage Capillary-Pressure Functions and the Influence of Connate Water

Study of the efficiency of trapped gas displacement by non-hydrocarbon gases from water-flooded gas condensate reservoirs

Parametric Investigation of the Gas-Assisted Gravity Drainage Technique

Physical simulation for water invasion and water control optimization in water drive gas reservoirs

Miscible Gas Injection in Undersaturated Gas-Oil Systems

Effect of injection rate, initial water saturation and gravity on water injection in slightly water-wet fractured porous media

Novel Method for Inverted Five-Spot Reservoir Simulation at High Water-Cut Stage Based on Time-Varying Relative Permeability Curves

Experimental influence assessments of water drive and gas breakthrough through the CO 2 -assisted gravity drainage process in reservoirs with strong aquifers

CFD Analysis of Pore Morphology, Gravity, and Fluid Characteristics Influences on Water Flooding Process