Lamellar Phase of Rod-Coil Diblock Copolymer Based on Mesogen-jacketed Liquid Crystalline Polymer: A Study of Chain Stretching
Xuan-bo Liu,Jia-ru Xu,Yong-feng Zhao,Shuang Yang,Xing-he Fan,Er-qiang Chen
DOI: https://doi.org/10.11777/j.issn1000-3304.2017.17145
2017-01-01
Acta Polymerica Sinica
Abstract:We have studied the microphase phase separation behavior of a series of rod-coil diblock copolymers with poly(2,5-bis[4-methoxyphenyl]oxycarbonyl)styrene) (PMPCS) as the rod and poly(epsilon-caprolactone) (PCL) as the coil. PMPCS is a typical mesogen-jacketed liquid crystalline polymer, of which the hexatic columnar nematic (Phi(HN)) phase can develop from the amorphous state upon heating irreversibly once the chain conformation becomes extended. It is found that the PCL-b-PMPCS samples with amorphous PMPCS behave similar to the coil-coil diblock copolymer, with the microphase separated morphology mainly determined by the volume fraction of PMPCS (f(PMPCS)). At the temperature above the glass transition temperature of PMPCS (similar to 116 degrees C), the transition from amorphous phase to Phi(HN) phase of PMPCS blocks occurs. This induces the "order-order" and/or "disorder-order" transition of the phase morphology, resulting in the lamellar morphology existing in a wide range of f(PMPCS) from 40% to 80%. In this case, PCL-b-PMPCS presents the typical feature of rod-coil diblock copolymer. Using one-dimensional correlation function to analyze the small-angle X-ray scattering data measured at 200 degrees C, we obtained the thicknesse of PMPCS and PCL domain (L-PMPCS and L-PCL) in the lamellar structures. A linear relationship is identified, L-PMPCS = 0.2N(PMPCS) (nm), with N-PMPCS as the degree of polymerization of PMPCS block. As the chain axis of PMPCS block is parallel to the normal of the lamellae, we conclude that the diblocks form a "single-layer smectic A" lamellar phase, and more importantly, L-PMPCS is the extended chain length of PMPCS block, which can be well controlled by polymerization. For PCL block, a scaling of L-PCL similar to N-PCL(0.85) (N-PCL is the degree of polymerization of PCL block) is observed, indicating that the molten PCL block is highly stretched. We further estimated the interfacial area per rod-like PMPCS (S/X) in the lamellar phase, which is always smaller than the cross section area of PMPCS rod in the Phi(HN) phase. Combining with the liquid crystallinity of samples measured by wide-angle X-ray diffraction, we consider that the variation of S/X reflects that, near the PMPCS/PCL interface, the PMPCS segments are not packed in Phi(HN) phase. This is mainly due to the strong segregation between the molten PCL and the liquid crystalline PMPCS which can cause the PMPCS blocks to be further stretched. For a fixed N-PCL, the smaller S/X is, the larger L-PCL is. However, a linear relationship of L-PCL(S/X) = 0.21N(PCL) (nm(3)) can be realized, wherein the value of slope is the volume of PCL repeating unit.