Abstract:Background: Nebulizers used to treat prehospital emergency patients should provide a high output efficiency to achieve a fast onset of therapeutic drug effects while remaining unaffected by the presence of supplementary oxygen flow or the patient's breathing pattern. On the other hand, nebulizer performance is directly influenced by differences in device design, gas flow and patients' breathing patterns. Several studies from emergency departments were able to demonstrate an improvement in patient outcome when using a mesh nebulizer instead of a jet nebulizer. Data or bench studies regarding prehospital care are non-existent. Objective: The aim of the present in vitro study was to evaluate which type of aerosol generator would best address the requirements of a prehospital adult emergency patient suffering from respiratory distress. Material and methods: We evaluated the performance of a jet nebulizer (Cirrus™ 2, Intersurgical®) and two mesh nebulizers (Aerogen Solo® with USB controller, Aerogen Limited and M‑Neb® mobile, NEBU-TEC International med. Produkte Eike Kern GmbH) with the possibility of portable operation in an in vitro model of a spontaneously breathing adult emergency patient. One physiological and three pathological breathing patterns (distressed breathing pattern as well as stable and acute exacerbated chronic obstructive pulmonary disease) were simulated. Nebulizer output and salbutamol lung deposition were measured at different oxygen flow rates using a face mask as the delivery interface. Results: The mesh nebulizers produced a significantly higher aerosol output when compared to the jet nebulizer. The M‑Neb® mobile was able to significantly exceed the output of the Aerogen Solo®. Oxygen flow had the largest influence on the output of the jet nebulizer but hardly affected the mesh nebulizers. After a nebulization time of 10 min the M‑Neb® mobile also achieved the highest total salbutamol lung deposition (P < 0.001). Aerosol drug deposition was therefore mainly determined by the nebulizer's drug output per unit time. The deposition could not be improved using a spacer but was strongly influenced by the simulated emergency patients' breathing pattern. Conclusion: The use of mesh nebulizers might have the potential to improve the aerosol therapy of prehospital emergency patients. In general, mesh nebulizers seem to be superior to jet nebulizers regarding aerosol output per unit time and total lung deposition. The present data suggest that aerosol output and drug deposition to the collection filter in this simulated setting are closely connected and crucial for total salbutamol deposition, as the deposition could not be improved by adding a spacer. Aerosol drug deposition in simulated emergency patients' lungs is therefore mainly determined by the nebulizer's drug output per unit time. The level of oxygen flow used had the largest influence on the output of the jet nebulizer but hardly affected the output of the tested mesh nebulizers. Mesh nebulizers could therefore enable a demand-adapted oxygen therapy due to their consistent performance despite the presence of oxygen flow. A high respiratory rate was associated with a high drug deposition, which is clinically desirable in the treatment of patients in respiratory distress; however, drug underdosing must also be expected in the treatment of bradypneic patients. Further clinical studies must prove whether our findings also apply to the treatment of real prehospital emergency patients.

Efficiency of Air Compressor-Driven Nebulizers

Effect of Nebulizer Location and Spontaneous Breathing on Aerosol Delivery During Airway Pressure Release Ventilation in Bench Testing

Interchanging Reusable and Disposable Nebulizers Used with Home-Based Compressors May Result in Inconsistent Dosing: A Laboratory Investigation with Device Combinations Supplied to the US Healthcare Environment

Factors Determining Continuous Infusion Aerosol Delivery During Mechanical Ventilation

In-vitro/in-vivo comparison of inhaled salbutamol dose delivered by jet nebulizer, vibrating mesh nebulizer and metered dose inhaler with spacer during non-invasive ventilation

Effect of Aerosol Devices and Administration Techniques on Drug Delivery in a Simulated Spontaneously Breathing Pediatric Tracheostomy Model

Physicochemical aspects and efficiency of albuterol nebulization: comparison of three aerosol types in an in vitro pediatric model

Albuterol Delivery Efficiency in a Pediatric Model of Noninvasive Ventilation With a Single-Limb Circuit

In Vitro Comparison of Aerosol Delivery in High-Frequency Assisted Airway Clearance Devices With Integrated Nebulizers

Comparison of Vibrating Mesh, Jet, and Breath-Enhanced Nebulizers During Mechanical Ventilation

[Can mesh nebulizers improve prehospital aerosol therapy? An in vitro study on simulated prehospital emergency patients suffering from respiratory distress]

Multidrug Aerosol Delivery During Mechanical Ventilation

Evaluation of antibody drug delivery efficiency via nebulizer in various airway models and breathing patterns

Dissecting the performance of a jet nebulizer: The effect of changing design parameters and operating conditions

Delivered dose with jet and mesh nebulisers during spontaneous breathing, noninvasive ventilation and mechanical ventilation using adult lung models

Atomization Efficacy of a Novel Micro-Dose Mesh Nebulizer (CVS-100) Versus the Traditional Mesh Nebulizer (M102) in Adults with Chronic Obstructive Pulmonary Disease: A Randomized Non-Inferiority Clinical Trial.

The function profile of compressed-air and ultrasonic nebulizers

Efficacy and usability of a novel nebulizer targeting both upper and lower airways

Radioaerosol Pulmonary Deposition Using Mesh and Jet Nebulizers During Noninvasive Ventilation in Healthy Subjects

Response to Bronchodilators Administered via Different Nebulizers in Patients With COPD Exacerbation

Compatibility and aerosol characteristics of formoterol fumarate mixed with other nebulizing solutions