Catalytic deoxygenation of carboxyl compounds in the hydrothermal liquefaction crude bio-oil via in-situ hydrogen supply by CuO-CeO2/ γ -Al2O3 catalyst

Hongbiao Du,Qi Yu,Guohua Liu,Jie Li,Jinglai Zhang,Wenjia Wang,Guoyi Duan,Yanghao Meng,Haijiao Xie
DOI: https://doi.org/10.1016/j.fuel.2022.123367
IF: 7.4
2022-06-01
Fuel
Abstract:Hydrothermal liquefaction (HTL) has drawn great attention as a potential method to produce bio-oil from biomass waste. However, bio-crude from HTL shows undesired high-oxygen content and needs further deoxygenation upgrading. Herein, stearic acids as a model carboxylic compounds in HTL bio-crude was employed to investigate catalytic deoxygenation performance. Results showed that (CuO) 10 -CeO2/ γ -Al2O3 had the most superior catalytic deoxygenation performance for the stearic acids. The maximum stearic acid conversion rate (96.36%) and total hydrocarbon yield (88.79%) were obtained at 300 °C , 12 h , ratio of stearic acid to water 1 : 4 . The main catalytic deoxygenation pathways were proposed: carbon monoxide generation (decarbonylation) – in-situ hydrogen generation (water–gas shift) – short-chain fatty acid generation (hydrogenolysis) – n-alkanes generation (decarboxylation, hydrodeoxygenation and hydrogenation). DFT calculation elucidated that CuO-CeO2 reduced the activation energy from 24.8 kcal mol −1 (vacuum) to 15.0 kcal mol −1 (catalytic). Thus, deoxygenation via CuO-CeO2/ γ -Al2O3 would be an effective method for upgrading HTL bio-crude.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?