Abstract:All‐polymer solar cells (all‐PSCs) have attracted extensive attention for their advantages in long‐term thermal‐ and photostability. However, the power conversion efficiencies (PCEs) of all‐PSCs still lag behind organic solar cells based on small molecular acceptors. The long chain entanglement between polymers brings complex morphological problems, which contributes to lower fill factor (FF). Herein, we propose an effective approach to build the ideal morphology and pseudo‐p‐i‐n vertical component distribution in all‐polymer active layer by independently casting donor and acceptor films with different solvents. Through the solvent engineering, the layer‐by‐layer device with o‐xylene and carbon disulfide (O‐XY:CS2)‐processed D18 donor layer achieved a PCE of 17.53%, much higher than commonly used solvents (chloroform (CF) and chlorobenzene (CB))‐processed donor layers with PCEs of 16.49 and 16.04%, respectively. In‐depth investigation reveals outstanding performance of O‐XY:CS2‐processed donor layer device is attributed to mitigated bimolecular recombination, more balanced mobility, and reduced trap density of states, which contributes to the enhancement of short current density (JSC) and FF. Moreover, favorable morphology network also brings prolonged lifetime under continuous light‐soaking. This work presents a simple and effective way to obtain ideal active layer morphology and construct favorable vertical component distribution through optimizing donor morphology in all‐PSCs. This article is protected by copyright. All rights reserved.

Optimized active layer morphology via side-chain atomic substituents to achieve efficient and stable all-polymer solar cells

A Top‐Down Strategy to Engineer ActiveLayer Morphology for Highly Efficient and Stable All‐Polymer Solar Cells

Optimizing the Morphology of All-Polymer Solar Cells for Enhanced Photovoltaic Performance and Thermal Stability

Rational design of conjugated side chains for high-performance all-polymer solar cells

Improving the Performance of Polymer Solar Cells by Altering Polymer Side Chains and Optimizing Film Morphologies

Optimized Active Layer Morphology Toward Efficient and Polymer Batch Insensitive Organic Solar Cells

High Efficiency Layer‐by‐Layer All‐Polymer Solar Cell Enabled by Bottom‐Layer Optimization

Improving Performance of All‐Polymer Solar Cells Through Backbone Engineering of Both Donors and Acceptors

Improving Active Layer Morphology of All-Polymer Solar Cells by Dissolving the Two Polymers Individually

Side Chain Engineering of Polymer Acceptors for All-Polymer Solar Cells with Enhanced Efficiency

Morphology Control Realizes Fast Charge Dissociation and Transport in High-Performance All-Polymer Solar Cells

Morphology Optimization Via Side Chain Engineering Enables All Polymer Solar Cells with Excellent Fill Factor and Stability

Optimizing Light‐Harvesting Polymers Via Side Chain Engineering

Understanding the Impact of Side-Chains on Photovoltaic Performance in Efficient All-Polymer Solar Cells

Optimizing the Phase-Separated Domain Size of the Active Layer Via Sequential Crystallization in All-Polymer Solar Cells.

High performance all-polymer solar cells enabled with solvent and solid dual additives

Layer-by-layer processed binary all-polymer solar cells with efficiency over 16% enabled by finely optimized morphology

Understanding the molecular mechanisms of the differences in the efficiency and stability of all-polymer solar cells

Manipulating Polymer Backbone Configuration via Halogenated Asymmetric End-Groups Enables Over 18% Efficiency All-Polymer Solar Cells

Understanding the Impact of Oligomeric Polystyrene Side Chain Arrangement on the All‐Polymer Solar Cell Performance

A polymer acceptor with double-decker configuration enhances molecular packing for high-performance all-polymer solar cells