Abstract:Compression plates are widely used in orthopaedic surgeries for internal fixation of fractured femurs. To fix the plate and thus to provide compression to a fracture, the self-tapping bone screws are tightened through predrilled pilot holes of smaller diameter. Preliminary investigation showed that the holes drilled with the inappropriate cutting parameters cause mechanical and thermal damages to the local host bone, which further lead to loosening of internal fixations. In this paper, the mechanistic models to predict the thrust forces and torques during bone drilling were developed, using a 3.20 mm diameter drill bit. As a procedure, the cutting action was investigated at three different regions of the drill point, namely cutting lips, secondary cutting edges and indentation zone. The models employed the analytical approach to account for the drill-bit geometry and cutting parameters, and an empirical approach to account for the material and friction properties. To complete the procedure, calibration experiments were conducted on bovine cortical femurs with two different spindle speeds (1000 and 3000 r/min) and feeds (0.03 and 0.06 mm/rev), and then the specific normal and friction coefficients were determined. The developed mechanistic models were validated with different ranges of parameters (500–3500 r/min speeds, and 0.02–0.07 mm/rev feeds) those commonly involved in manual and robot-assisted surgery. The validation study revealed that the thrust forces predicted using the mechanistic models showed a maximum error of only 5.80%. However, the torques predicted from the mechanistic model found with more error than the thrust forces. The predominant reasons for this under-prediction might because of the extrapolation used to determine the specific cutting pressures, slip-line field applied to the indentation zone instead of compressive fracture, and chip clogging involved during the bone drilling as demonstrated in earlier studies. Despite the deviations, the developed mechanistic models satisfactorily follow the trends of the thrust forces and torques experienced during bone drilling. The outcomes can be used to practice the bone drilling procedure and monitor the effect of process parameters on thrust forces and torques in the in-silico environment before performing actual surgery.

Modeling and verification of cortical bone drilling forces based on tissue structure heterogeneity

A Multiscale Evaluation of the Surface Integrity in Boring Trepanning Association Deep Hole Drilling

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Experimental Study On Drilling Force During Mandible Drilling Process

Experimental analysis of drilling process in cortical bone.

Mechanistic models to predict thrust force and torque in bone drilling: An in-vitro study validated with robot-assisted surgical drilling parameters

Investigation of Force Modeling in Ultrasonic Vibration-Assisted Drilling SiCf/SiC Ceramic Matrix Composites

On the importance of precision in cortical bone drilling: Integrating experimental validation and computational modeling

Modeling and experimental investigation of drilling force for low-frequency axial vibration-assisted BTA deep hole drilling

Study on the predicted model and experiment of drilling forces in drilling Ti6Al4V

Modelling of Thrust Force for Worn Drill Bits Characterised by Cutting Edge Radius in Drilling Carbon Fibre–reinforced Plastic/ti-6Al-4v Alloy Stacks

Modeling and experimental analysis of ultrasonic vibration drilling force prediction model for tiny small holes in high body fraction aluminum-based silicon carbide composites

Drilling Performance of Non-Coaxial Helical Flank Micro-Drill with Cross-Shaped Chisel Edge

Thrust Force Model for Ultrasonic-Assisted Micro Drilling of DD6 Superalloy

Modeling of Burr Height in Ultrasonic-Assisted Drilling of DD6 Superalloy

Predicting and Verifying Forces on Boring Parameters

Model of Ploughing Cortical Bone with Single-Point Diamond Tool

Mechanics of thrust force on chisel edge in carbon fiber reinforced polymer (CFRP) drilling based on bending failure theory

A novel self-centring drill bit design for low-trauma bone drilling

Investigation of transient machining in the cortical bone drilling process by conventional and axial vibration-assisted drilling methods

A novel prediction model for thrust force and torque in drilling interface region of CFRP/Ti stacks