Abstract:Vanadium dioxide (VO2) is considered one of the most promising smart thermal control materials due to its insulator-metal temperature (IMT) reversible phase transition, accompanied by large changes in its optical properties. However, as the crystal defects on IMT change and the optical property of VO2 is still unclear, the preparation of doped VO2 films by magnetron sputtering is still a great challenge. In this work, the IMT of 41 kinds of doping-VO2 systems were studied by high throughput calculation based on density functional theory (DFT). It was found that the IMT increased with the decrease of the β angle in M phase and expansion of cell volume difference of M-phase and R-phase for IIA elements, VIIA elements, transition elements, and rare earth element doped VO2, and increased with the increase of the β angle in M phase and a decrease of cell volume difference of M-phase and R-phase for IA, IVA, VA, and VIA element doped VO2. According to the rule, the IMT, electronic structures, and optical properties of W doped VO2 were studied based on DFT. The results show that IMT and bandgap decrease with the increase of W6+ ion concentration, which is due to the increased cell volume difference of M-phase and R-phase in W doped VO2; each doped atom can reduce the IMT of 20.2 °C, and the IMT of V0.98W0.02O2 is close to room temperature (Tc ≈ 27 °C). The rate of infrared emissivity (∆ɛ) of V0.98W0.02O2 is about 0.2 at 8–14 μm (0.088–0.155 eV) and the average solar absorption (αs) of M phase and R phase is about 0.53 and 0.59 at 0.3–1.5 μm (0.496–4.13 eV), respectively. Finally, radio frequency magnetron sputtering was used to achieve precise doping, which solved the problem of oxygen partial pressure in reactive magnetron sputtering, and V1-xWxO2 films with IMT close to room temperature and narrow hysteresis width were prepared. This is due to the fact that higher W doping content will greatly increase the density of defect-induced nucleation sites and promote nucleation. At the same time, the experimental results of IMT were consistent with the calculated results, which proved the reliability of the calculation. This will provide a theoretical basis for the development of new thermal control materials and a new method for the preparation of doping-VO2 films in the future.

Enhanced phase transformation properties of VO2(M) powder by Ti doping

Thermal-stimulated Phase Transition of Vanadium Dioxide Enabling Versatile Transduction and Smart Applications

Snowflake-Like Monoclinic VO2 Powders: Hydrothermal Synthesis, Characterization and In Situ Monitoring Phase-Transition Behavior

Decoupling the Lattice Distortion and Charge Doping Effects on the Phase Transition Behavior of VO2 by Titanium (ti(4+)) Doping.

Synthesis, structure and properties of printable W-doped thermochromic VO2 with a low phase transition temperature

Regulation of Phase Transition Temperature and Preparation for Doping-Vo2 Smart Thermal Control Films

Phase, Microstructure, Thermochromic, and Thermophysical Analyses of Hydrothermally Synthesized W-Doped VO2 Nanopowder

Anisotropic Optical Response of Ti-Doped VO2 Single Crystals

The Visible Transmittance and Solar Modulation Ability of VO2 Flexible Foils Simultaneously Improved by Ti Doping: an Optimization and First Principle Study.

Effect of Fe Doping on Thermochromic Properties of VO 2 Films

Controllable morphology, structure and optical properties of W–Eu Co-doped VO2 with a tunable phase transition temperature and band gap

Raman scattering of TixV1‐xO2 thin films on (110) rutile TiO2 in the low and high temperature phase adjacent to the metal–insulator transition

The Phase Transition of W-Doped VO<SUB>2</SUB> Nanoparticles Synthesized by an Improved Thermolysis Method

Tuning Phase Transition and Thermochromic Properties of Vanadium Dioxide Thin Films via Cobalt Doping.

One-step ball milling synthesis of VO2 (M) nanoparticles with exemplary thermochromic performance

Modulation of VO2 metal-insulator transition by co-doping of hydrogen and oxygen vacancy

Systematic Exploration of the Synthetic Parameters for the Production of Dynamic VO2(M1)

Investigation on Microstructures and Phase Transition Characteristics of Titanium/yttrium Co-Doped Vanadium Oxide Thin Films

Microwave Hydrothermal Preparation of VO2

Regulation of morphology and structure of vanadium dioxide via a hydrothermal method for optimizing performances

Effects of V<sub>2</sub>O<sub>5</sub> on the synthesis of Ba<sub>2</sub>Ti<sub>9</sub>O<sub>20</sub> powders