Wave Force Characteristics on a Bottom-pivoted Test Cylinder in the Splash Zone

N. Haritos
Abstract:This paper investigates the interaction of a wide variety of gravity waves with a surface piercing bottom pivoted segmented test cylinder in the splash zone in the Morison loading regime from a series of experiments conducted in a wave basin. The splash zone here is defined as the region from the bottom-most trough to the upper-most crest including wave runup on the cylinder concerned. A series of irregular waves conforming to Pierson-Moskowitz wave spectra in uni-directional sea states as well as quasi-regular swept sine waves (SSWs) and another series that considered multidirectional sea states with two different degrees of directional spread were treated in this investigation. Nine abutting segments in the cylinder, of various lengths, were instrumented for inline and transverse force components. The orthogonal force components in these directions were also measured at the tip supports of the cylinder. A single segment, the longest in the group, was located to ensure capture of the entire splash zone. The orthogonally disposed rigid supports at the top end of the cylinder were also replaced by a set of springs with three different degrees of compliancy to allow dynamic excitation of the test cylinder by the selected wave climates in order to obtain a more comprehensive investigation of the wave-structure interaction in the splash zone and below this zone. Fundamental results obtained suggest that the Morison inertia force coefficients in the splash zone exhibit a frequency dependency and are lower than the corresponding values for the fully wetted segments and for the cylinder as a whole. In addition, the adoption of results for these coefficients from uni-directional waves is conservative for more realistic ocean waves that would exhibit directional spread. Whilst for these tests the drag force was quite small when compared with inertia force in the Morison forcing regime for Keulegan Carpenter numbers less than ~10, it was found that this force component plays a significant role in introducing a hydrodynamic damping contribution to an otherwise very low damping scenario in the case of a compliant cylinder. Results from these fundamental studies are of particular relevance to designers of offshore structures such as oil rigs/platforms and in the case of bottom-pivoted cylinder designs for tapping renewable energy from ocean wave power.
Engineering,Environmental Science,Physics
What problem does this paper attempt to address?