Abstract:Ilmenite is one of the main magnetic materials in nature. Ilmenite-type oxides (general formula ABO3) are widespread and interest in material science, crystal chemistry and geosciences. They are often found in natural minerals from the Earth’s interiors. Therefore, the structural change of ilmenite under pressure is thus useful for understanding in the Earth’s mantle. Along with ilmenite, FeTiO3 can form two other polymorphs: perovskite and lithium niobate (LiNbO3) [1]. The structures of ilmenite and LiNbO3 are closely related and are characterized by different orderings of the A and B cations. The ilmenite structure was reported [2] and studied at high pressure and temperature [3]. The polymorphs are theoretically predicted at high pressures [4]. Ilmenite naturally occurs and is the most stable polymorph at ambient conditions. The ilmenite structure is based on an oxygen hexagonal-close-packed lattice with metal atoms, which occupy two-thirds of the available octahedral sites and form honeycomb-like layers of edge-shared octahedra. Furthermore, FeTiO3 undergoes phase transitions from the ilmenite phase to the perovskite phase at pressures above 20 GPa. The perovskite phase transforms to LiNbO3 phase upon decompression [5]. A variety of charge and spin states induce a complicated phase diagram involving magnetic, electronic, and structural transitions. The electrical resistivity measurement of ilmenite FeTiO3 at high pressures and/or at high temperatures is a significant subject to understand the electronic state. Andreozzi et al. performed conductivity measurements on synthetic FeTiO3 and natural ilmenite at high temperatures and at different oxygen partial pressures [6]. The pressure dependence of the resistivity has been studied [7] using synthetic ilmenite samples. The electrical conductivity of FeTiO3 ilmenite has been reported at both high pressure and high temperature [8]. The electron density distribution of FeTiO3 ilmenite was clarified under high pressure through maximum entropy method (MEM) using singlecrystal diffraction intensities, and the anisotropic electrical conductivity was proposed. And, electrical resistance measurements of polycrystalline samples of FeTiO3 under pressure revealed that FeTiO3 becomes more conductive as the pressure increases [9]. However, the observed resistance is averaged in the bulk powder sample. Therefore, we aim to determine the pressure dependence of the resistivity and to elucidate the effect of anisotropic deformation of the crystal structure. Ilmenite single crystals were synthesized using the floating method. Thin crystal plates parallel and perpendicular to the c-axis were prepared. We used a diamond anvil cell for pressure genaration. The pressure dependence of the resistance at room temperature was measured parallel and perpendicular to the c-axis. Pressures were determined using a ruby fluorescence system [10]. A mixture of c-BN and epoxy resin formed an insulating layer on the gasket. Alkaline metal halides (NaCl) were used as pressure media. Four Au electrodes were connected to the single-crystal sample.

Anisotropic electrical conductivity changes in FeTiO3 structure transition under high pressure

Pressure dependence of electrical conductivity in FeTiO 3 Ilmenite

High Pressure in Situ Differential Thermal Analysis of Na0.5Bi0.5TiO3 Phase Transitions Up to 5 GPa

Pressure-induced phase transition of Fe 2TiO 4: X-ray diffraction and Mössbauer spectroscopy

High-pressure phase transitions of Fe[subscript 3x]Ti[subscript x]O[subscript 4] solid solution up to 60 GPa correlated with electronic spin transition

Pressure-Induced Reversible Hcp to Fcc Phase Transition of Ti: A First-Principles Study

Anisotropy in Elasticity and Physical Properties of Ti2B under High Pressure

High-Pressure Phase Transitions Of Fe3-Xtixo4 Solid Solution Up To 60 Gpa Correlated With Electronic Spin Transition

Revision 2 1 2 High-pressure phase transitions of Fe 3-xTixO 4 solid solution 3 up to 60 GPa correlated with electronic spin transition

Pressure‐induced phase transition and elastic properties of TiO2 polymorphs

Pressure-induced phase transition and elastic properties of TiO<sub>2</sub>polymorphs

In situ high-pressure study of LiNbO3-type FeTiO3: X-ray diffraction and Mossbauer spectroscopy

Iron Oxidation State Offetio3under High Pressure

Negative Pressure Induced Ferroelectric Phase Transition in Rutile TiO2

Pressure and Temperature-Dependent Optical Properties of TiTa2O7

Pressure-Induced Structural Evaluation And Insulator-Metal Transition In The Mixed Spinel Ferrite Zn0.2mg0.8fe2o4

Abnormal Elastic Changes for Cubic-Tetragonal Transition of Single-Crystal SrTiO3

Structure Evolution, Elastic And Electronic Properties Of Pt-Doped Ti Alloy Under Pressure

Structural Stability of TiO2 at High Pressure in Density-Functional Theory Based Calculations.

Successive phase transitions under high pressure in FeTe0.92

Impact-Parameter Dependence of the Diagonal GPD of the Pion from Chiral Quark Models