Abstract:Abstract This paper demonstrates the importance of a proper contact algorithm selection when a constitutive model is correlated and validated, especially in the case of brittle materials. A parametric study is carried out to study the influence of contact parameters on the outcomes of the numerical simulations of a dynamic compression test. The split Hopkinson pressure bar (SHPB) model is developed, and sandstone rock is considered as a representative material having considerably different properties compared to SHPB bars. The finite element method (FEM) and smoothed particle hydrodynamics (SPH) were used to simulate specimen behaviour using a LS-Dyna solver. Two contact types based on the penalty method are analysed: nodes to surface (FEM and SPH) and surface to surface (FEM only). Furthermore, three approaches of contact stiffness calculation are used for each contact type. The waveform data and failure patterns are then compared among all simulated cases and the corresponding experimental outcomes. It is found that the soft constraint stiffness ( SOFT = 1) provides the best outcomes, especially in the case of one-way contact, and is nearly insensitive to stiffness scaling parameters. By contrast, standard ( SOFT = 0) and segment-based ( SOFT =2) approaches require a substantial effort in adjusting the stiffness scaling parameters to obtain satisfactory results. This paper provides valuable guidance for correlating and validating parameters of constitutive models for rock and other brittle materials in the SHPB test.

Experimental investigation of the effects of debris on non-conforming contact stress

Debris effect on the surface wear and damage evolution of counterpart materials subjected to contact sliding

Experimental Characterization of Frictional Line Contact by Digital Image Correlation and Inverse Method

A Network-Based Investigation on the Strong Contact System of Granular Materials under Isotropic and Deviatoric Stress States

Modeling and Experimental Characterization of Contact Boundary Tractions in Non-Conforming Contact with Random Defects

Modeling and Experimental Investigations on the Relationship Between Wear Debris Concentration and Wear Rate in Lubrication Systems

Effects of Surface Stresses on Contact Problems at Nanoscale

An Indirect Experimental Measurement Method for Contact Length Identification in Non-conforming Frictionless Contact

Optimization of Elastoplastic Behavior of Contact Interface for Improved Contact Stress Distribution

LANDSLIDE STABILITY ANALYSIS BY THE 3D ELASTIC PLASTIC CONTACT FINITE ELEMENT ALGORITHM

Experimental and Finite Element Analysis of Plastic Domain Evolution of Rough Surfaces during Contact

Stability analysis of an ancient debris landslide by elastic-plastic contact FEM

Time-dependent Deformation in High Concrete-Faced Rockfill Dam and Separation Between Concrete Face Slab and Cushion Layer

Simulation and experimental investigation on the eccentric collision in multi-body systems considering the friction effect

Nonlinear Characteristics of Revolute Joints with Clearance

Study of Contact Algorithms Influencing Specimen Response in Numerical Simulation of Dynamic Compression Test

The Influence of Fractal Dimension in the Microcontact of Three-Dimensional Elastic-Plastic Fractal Surfaces

Modeling and Experimental Identification of Contact Pressure and Friction for the Analysis of Non-Conforming Elastic Contact

Effect of reinforcement on wear debris of carbon nanofiber/high density polyethylene composites: Morphological study and quantitative analysis

Experimental Investigation on Effects of Surface Texturing on Lubrication of Initial Line Contacts

Contact Force Measurement And Delaminating Responses Of Composite Laminate Subjected To Small-Mass Impact