Abstract:Membrane biofouling represents a major challenge ever-present in the practical application of polyamide (PA) thin-film composite (TFC) reverse osmosis (RO) membranes. This work focused on grafting polyacrylamide (PAAm) onto PA-TFC via an in-situ atomic transfer radical polymerization (ATRP) method to improve the biofouling resistance of PA-TFC. The ATRP initiators, isobutyryl bromide (iPB), were introduced into PA matrix using a bifunctional small molecule, 2-bromoisobutyryl bromide (BIBB), added in organic hexane solutions to participate in interfacial polymerization through the condensation reaction with m-phenylenediamine. The successful introduction of iPB was confirmed by membrane surface characterizations, and the iPB density in PA layer was tuned by varying the BIBB concentrations in hexane solutions based on the variation in water permeance and salt rejections of iPB-loaded PA-TFC. The ATRP for the gradual growth of PAAm brush was thus in-situ achieved on the PA-TFC surface from the pre-incorporated iPB groups and the length of PAAm chains was facilely controlled via tuning ATRP polymerization time. The PAAm grafted PA-TFC exhibited a minimum decrement of water permeance and essentially retained salt rejections relative to the un-grafted ones. More importantly, the grafted membranes presented synergistically enhanced anti-adhesion and bacteriostatic performance towards either Gram-negative Escherichia coli (E. coli) or Gram-positive Bacillus subtilis (B. subtilis). Also, the grafted membranes presented a lower final flux decline ratio (FDRf) and higher final flux recovery ratio (FRRf) in relation with the un-grafted membranes in the dynamic bovine serum albumin (BSA) fouling test. Particularly, the membrane grafted with longer PAAm chains from extended grafting time showed better anti-biofouling performance: the sterilization ratio towards E. coli and B. subtilis achieved up to 98.8% and 99.0%, respectively, and FDRf of just 3.7% and FRRf of 97.6% after 3 × 8 h BSA fouling test for the membrane subjected to 2 h ATRP grafting. The PAAm grafting induced greater water wettability of membrane surface and the flexible chain structure of PAAm were proposed to account for the enhanced anti-adhesion and bacteriostasis towards bacteria, which collaboratively led to the improved biofouling resistance.

Modification of Electrospun Regenerate Cellulose Nanofiber Membrane via Atom Transfer Radical Polymerization (ATRP) Approach as Advanced Carrier for Laccase Immobilization

Preparation of Water-Insoluble Lignin Nanoparticles by Deep Eutectic Solvent and Its Application As a Versatile and Biocompatible Support for the Immobilization of Α-Amylase.

Functional and Surface-Active Membranes from Poly(vinylidene Fluoride)-Graft-poly(acrylic Acid) Prepared Via RAFT-mediated Graft Copolymerization.

Enzyme immobilization on ultrafine cellulose fibers via poly(acrylic acid) electrolyte grafts

Surface Modification of Nanofibrous Poly(acrylonitrile-Co-acrylic Acid) Membrane with Biomacromolecules for Lipase Immobilization

Preparation of Ph-Sensitive Membranes Via Dopamine-Initiated Atom Transfer Radical Polymerization

Improving the biofouling resistance of polyamide thin-film composite membrane via grafting polyacrylamide brush on the surface by in-situ atomic transfer radical polymerization

Nanofibrous Membranes Containing Reactive Groups : Electrospinning from Poly(acrylonitrile-Co-maleic Acid) for Lipase Immobilization

Immobilization Of Enzymes On A Phospholipid Bionically Modified Polysulfone Gradient-Pore Membrane For The Enhanced Performance Of Enzymatic Membrane Bioreactors

Covalent Immobilization of Lipase from Candida Rugosa Onto Poly(acrylonitrile-Co-2-hydroxyethyl Methacrylate) Electrospun Fibrous Membranes for Potential Bioreactor Application

Immobilization of Candida Rugosa Lipase on Electrospun Cellulose Nanofiber Membrane

Preparation of Coaxial-Electrospun Poly[bis(p-methylphenoxy)]phosphazene Nanofiber Membrane for Enzyme Immobilization

Entrusting Poly(Acrylonitrile-Co-Maleic Acid) Ultrafiltration Hollow Fiber Membranes with Biomimetic Surfaces for Lipase Immobilization

Immersion in Advanced Oxidation Water Followed by AGET-ATRP to Develop Low-Fouling Microfiltration Membranes by Grafting Poly(2-methoxyethyl Acrylate)

Development of a novel RAFT-UV grafting technique to modify polypropylene membrane used for NOM removal

Application of Surface-Initiated Atom Transfer Radical Polymerization on Preparing Functional Membrane

An electrochemically mediated ATRP synthesis of lignin-g-PDMAPS UCST-thermoresponsive polymer

Immobilization of Interfacial Activated Candida rugosa Lipase Onto Magnetic Chitosan Using Dialdehyde Cellulose as Cross-Linking Agent

Simple strategy to functionalize polymeric substrates via surface-initiated ATRP for biomedical applications

Enzyme immobilization on a pH-responsive porous polymer membrane for enzymatic kinetics study

Review on Applications of Atom Transfer Radical Polymerization on Polymeric Membrane's Hydrophilic and Functional Modification