Experimental investigation on ignition and burnout characteristics of semi-coke and bituminous coal blends

Shaowei Zheng,Yingjie Hu,Zhiqiang Wang,Xingxing Cheng
DOI: https://doi.org/10.1016/j.joei.2019.12.007
IF: 6.47
2020-08-01
Journal of the Energy Institute
Abstract:<p>Ignition and burnout characteristics of semi-coke and bituminous coal blends were investigated by thermogravimetric analyzer and drop tube furnace. The results showed that the ignitability index and the comprehensive combustion characteristic index of the blends decrease as the blending proportion of semi-coke increases, but the average activation energy of the blends increases gradually. Ignition mode of bituminous coal is changed from homogeneous to hetero-homogeneous ignition with the increasing of semi-coke content in the blends. When the mixing proportion of semi-coke is lower than 45%, the burnout rate is lower than the weighted value in the early stage of combustion and gradually higher than the weighted value with the development of combustion process. However, the burnout is always lower than the weighted value to mix with 67% semi-coke. Increasing furnace temperature from 850°C to 1050°C can improve the mid-term reaction process, alleviate the negative effects of semi-coke on the co-combustion process and increase the burnout rate. So less than 45% semi-coke blending ratio and increasing furnace temperature are recommended for semi-coke and bituminous coal co-combustion.</p>
energy & fuels
What problem does this paper attempt to address?