3D printed power source for point‐of‐care diagnostics

Lore Van Looy,Cesar Parra‐Cabrera,An Vanduffel,Jonas Adriaenssens,Philippe M. Vereecken,Rob Ameloot,Cesar Parra-Cabrera
DOI: https://doi.org/10.1002/adem.202302207
IF: 3.6
2024-01-29
Advanced Engineering Materials
Abstract:Point‐of‐care (POC) devices require more advanced detection techniques than those currently available to achieve enhanced quantification and sensitivity. Incorporating a micro power supply could be a viable solution to enable the implementation of these techniques. In recent years, paper‐based microfluidic galvanic cells (μGCs) have emerged as promising disposable power sources; however, the fabrication process remains labor‐intensive. This study demonstrates the potential of three‐dimensional printing (3DP) as a novel fabrication method for μGCs. The autonomous μGCs are fabricated using a powder‐based 3DPed method, resulting in a porous body in which capillary forces enable the coflow of redox‐active solutions. As a proof of concept, a handheld glucometer is powered by coupling four μGCs in series. This article is protected by copyright. All rights reserved.
materials science, multidisciplinary
What problem does this paper attempt to address?