Encapsulation of Plant Oils in Porous Starch Microspheres

Gregory M. Glenn,Artur P. Klamczynski,Delilah F. Woods,BorSen Chiou,William J. Orts,Syed H. Imam
DOI: https://doi.org/10.1021/jf9037826
IF: 6.1
2010-03-02
Journal of Agricultural and Food Chemistry
Abstract:Natural plant products such as essential oils have gained interest for use in pest control in place of synthetic pesticides because of their low environmental impact. Essential oils can be effective in controlling parasitic mites that infest honeybee colonies, but effective encapsulants are needed to provide a sustained and targeted delivery that minimizes the amount of active ingredient used. The present study reports the encapsulation of essential oils in porous microspheres that are within the size range of pollen grains and can be easily dispersed. The microspheres were made by pumping an 8% aqueous high-amylose starch gelatinous melt through an atomizing nozzle. The atomized starch droplets were air-classified into two fractions and collected in ethanol. The size range for each fraction was measured using a particle size analyzer. The mean particle size for the largest fraction was approximately 100 microm with a range from 5 microm to over 300 microm. Part of the reason for the large particle size was attributed to the merging of smaller particles that impinged upon each other before they solidified. The smaller fraction of spheres had a mean particle size of approximately 5 microm. The starch-based porous microspheres were loaded with 16.7% (w/w) essential oils including thymol (5-methyl-2-isopropylphenol), clove, origanum, and camphor white oil. The essential oils appeared to be largely sequestered within the pore structure, since the spheres remained a free-flowing powder and exhibited little if any agglomeration in spite of the high loading rate. Furthermore, SEM micrographs verified that the pore structure was stable, as evidenced by the persistence of pores in spheres that had first been loaded with essential oils and then had the oil removed by solvent extraction. Thermal gravimetric analyses were consistent with a loading rate at predicted levels.
food science & technology,chemistry, applied,agriculture, multidisciplinary
What problem does this paper attempt to address?