Experimental study and turbulence dissipative scale modelling of the rapid micromixing of impinging thin sheets of liquids

Robert J. Demyanovich
DOI: https://doi.org/10.1016/j.cherd.2024.04.060
IF: 4.119
2024-05-09
Chemical Engineering Research and Design
Abstract:Highlights • Micromixing of impinging sheets was studied experimentally; modeled using a fluid mechanical approach. • Novel fluorescent experimental technique used to determine micromixing slab size ( 2L ). • 2L is similar to dissipation microscales in a turbulent flow. • Relationship of 2L to the ratio of kinematic viscosity to energy dissipation rate is similar to the Taylor microscale. • Relationship of 2L to the large eddy Reynolds number is analogous to the Kolmogorov microscale. Previous studies have shown that the impingement of thin liquid sheets produces high energy dissipation rates due to the release of kinetic energy in a very small mass of liquid (0.0001 to 0.01 g), even though flowrates are on the order of L/min. Rapid micromixing occurs because the dissipated energy leads to a substantial reduction in the initial segregation size scale of the liquids, which is the single-sheet thickness at impingement ( ~ 100 μ m). In the present study, the micromixing was investigated by following the progress of an acid-base neutralization accompanied by a change in fluorescence intensity of a fluorophore. Micromixing was modeled using a framework that assumes diffusion and reaction of species occur within slabs of fixed thickness ( 2L ). The slabs are fixed in size because the released kinetic energy is dissipated within one turnover time of the large energy-containing eddies produced in the turbulent impingement zone. A simulation, which included a module for calculating the fluorescence intensity, determined 2L for experimental energy dissipation rates ( ε ) ranging from 4 x 10 4 to 7.7 x 10 6 W/kg. 2L was found to lie in the range of turbulent dissipative scales less than the Taylor microscale but greater than the Kolmogorov microscale. 2L/v′ was found to be a function of ReΛ−1/4 and ν/ε1/2 , where v′ is the velocity associated with the turbulent kinetic energy, ReΛ is the large-eddy Reynolds number and ν is the kinematic viscosity. Similar to η/Λ , 2L/Λ is a function of ReΛ−3/4 , where η is the Kolmogorov microscale and Λ is the size of the large energy-containing eddies.
engineering, chemical
What problem does this paper attempt to address?