Complete mechanochemical defluorination of perfluorooctanoic acid using Al2O3 and Al powders through matching electron-mediated reduction with decarboxylation

Yuqi Zhou,Hanqing Lv,Jin Lin,Tianyu Lv,Nan Wang,Heqing Tang,Lihua Zhu
DOI: https://doi.org/10.1016/j.chemosphere.2022.135872
IF: 8.8
2022-11-01
Chemosphere
Abstract:This work reports a mechanochemical (MC) method for complete defluorination of perfluorooctanoic acid (PFOA) by using Al and Al2O3 as milling agents. Both the Al/Al2O3 molar ratio (nAl/nAl2O3) and the pre-thermal treatment of Al2O3 strongly influenced the defluorination of PFOA. When commercial γ-Al2O3 was pre-treated at 1200 °C, the use of Al and heat-treated γ-Al2O3 with nAl/nAl2O3 of 1: 1 led to PFOA defluorination of 100% after ball milling for 26 min at 350 rpm, being much higher than those (8.3%–58.1%) for using singlet milling agents or binary milling agents containing γ-Al2O3 pre-heated at temperatures lower than 700 °C. It was clarified that the carboxylate-mediated adsorption of PFOA on Al2O3 was essential for the MC decarboxylation as a degradation initiation step, and the in-situ generated electron on milled Al consequently caused the reductive dissociation of C–F bonds in the decarboxylation intermediate. A larger nAl/nAl2O3 increased the in-situ electron generation rate (re), and a higher heat-treatment temperature decreased OH−/H2O adsorbed on Al2O3 to low the PFOA decarboxylation rate (rdec). The re/rdec ratio determined defluorination pathways, and the percentage of the defluorination of PFOA in its total degradation including the generation of any degradation intermediates increased linearly with increasing re/rdec.
environmental sciences
What problem does this paper attempt to address?