Abstract:Masonry structures often exhibit poor seismic performance during earthquakes owing to their low material strength, structural integrity, and ductility. To address the mechanism of in-plane damage and collapse of masonry walls subjected to earthquake ground motion, three full-size brick walls, one with structural columns and two without structural columns, were designed and constructed in this experimental study to quantitatively investigate the effect of structural columns on the seismic performance of masonry walls. Quasi-static tests of masonry walls subjected to cyclic lateral loading were conducted using electrohydraulic servo actuators. The in-plane damage evolution and failure mode of the masonry walls under lateral loading were investigated. A numerical model with a novel plastic damage constitutive model of masonry was established. The accuracy of this model and the calculation results were verified by comparing them with the crack development and mechanical property curves obtained from the experiments. Based on the numerical model, a parametric analysis was conducted to investigate the influence of critical factors, such as mortar strength, vertical load, and height-to-width ratio, on the seismic performance of masonry structures. The test results showed that structural columns can effectively improve the performance of masonry structures. Properly installed structural columns can improve the peak load-bearing capacity, ductility, and energy dissipation of masonry structures. The masonry damage constitutive model used in this study could simulate the damage to masonry wall specimens well and reflect the hysteretic curves of the specimens within an acceptable range of accuracy. Thus, it provides a valuable reference for physical experiments. An appropriate mortar strength and vertical compressive stress can effectively enhance the load-bearing capacity of masonry structures within a certain range. For structural column walls. Walls with mortar strengths (average compressive strength) of 12.5 MPa, 10 MPa, 7.5 MPa, and 5 MPa showed an increase in peak bearing capacity of 26.2 %, 23.9 %, 18.5 %, and 9.4 %, respectively, compared to walls with mortar strengths (average compressive strength) of 2.5 Mpa. The aspect ratio had a significant impact on the shear load-bearing capacity of the masonry walls. An increase in the aspect ratio led to a transition from shear failure to flexural failure and a subsequent decrease in shear load-bearing capacity. For masonry walls with structural columns, increasing the diameter of the longitudinal steel in the structural columns can enhance the load-bearing capacity of the masonry wall, resulting in a significant improvement in its overall performance.

Estimation of Building Damage Due to Excavation-Induced Ground Movements

Estimation of building damage caused by adjacent deep excavation in clay

Cracking in Walls of a Building Adjacent to a Deep Excavation

Evaluation of Building Stiffness for Building Response Analysis to Excavation-Induced Ground Movements

Evaluating Damage Potential in Buildings Affected by Excavations

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

Responses of Buildings with Different Structural Types to Excavation-Induced Ground Settlements

Damage Based Constitutive Model for Predicting the Performance Degradation of Concrete

Damage assessment of unreinforced masonry buildings incorporating damage accumulation

Simplified Model for Evaluating Damage Potential of Buildings Adjacent to a Braced Excavation

Repairability and Damage Assessment of Controlled Rocking Masonry Walls with Energy Dissipation Accessible in a Steel Base

Slip-enhanced plastic-damage constitutive model for masonry structures

Damage evolution and failure mechanism of masonry walls under in-plane cyclic loading

Damage Identification in Masonry Wall Specimens: Shake Table Studies

Response of Building Adjacent to Stiff Excavation Support System in Soft Clay

Dynamic characteristics of stone masonry walls before and after damage: Experimental and numerical investigations

An application of finite element model updating for damage assessment of a two-story reinforced concrete building and comparison with lidar

Comparative evaluation of building responses to an adjacent braced excavation

Using image-based inspection data to improve response predictions of earthquake-damaged unreinforced masonry buildings

Simulation of Masonry Wall using Concrete Damage Plasticity Model

Analysis of Masonry Behavior on Non-engineered House Building Towards Lateral Deformation by Using Finite Element Method Based on Guidelines