Abstract:Detecting and diagnosing faults without a priori knowledge are important requirements in monitoring practical industrial processes. Principal component analysis (PCA) and multivariate contribution analysis (MCA) methods belong to this category of unsupervised monitoring methods. Because the processes' operation conditions and parameters may vary with time, there is a need to online update the monitoring statistics. This paper presents an adaptive approach for fault detection and diagnosis depending on an orthogonal iteration method, i.e., the fast data projection method (FDPM), which is known as the lowest complexity one among all known subspace tracking methods. The faults are first detected using four adaptive indices of PCA, i.e., Hotelling's T2, Hawkins' TH2, SPE, and a combined index ψ. Second, adaptive diagnosis methods based on multivariate contribution analysis (MCA) are used to diagnose faults in time-varying processes. The diagnosability of the adaptive diagnosis methods is investigated, and a comparison of the adaptive diagnosis methods for the four indices is conducted. The effectiveness of the adaptive PCA- and MCA-based diagnosis methods is demonstrated by three simulation studies: a numerical example, the continuous stirred-tank reactor (CSTR) chemical process, and the Tennessee Eastman process.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.iecr.0c04572?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.iecr.0c04572</a>.Process model and two PI controller parameters (Table S1) and process variables' initial conditions, nominal values, disturbances, and noises (Table S2) (<a class="ext-link" href="/doi/suppl/10.1021/acs.iecr.0c04572/suppl_file/ie0c04572_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Fault Detection and Isolation for Time-Varying Processes Using Neural-Based Principal Component Analysis

Sensor Fault Diagnosis of Nonlinear Processes Based on Structured Kernel Principal Component Analysis

Dynamic PCA-based Fault Detection and Diagnosis Analysis

Adaptive Partitioning Pca Model for Improving Fault Detection and Isolation

Fault Detection and Isolation of Non-Gaussian and Nonlinear Processes Based on Statistics Pattern Analysis and the K-Nearest Neighbor Method

PCA-based Fault Detection and Diagnosis with Application to Heavy Oil Fractionator

Shrinking principal component analysis for enhanced process monitoring and fault isolation

A Method Of Fault Diagnosis Based On Pca And Bayes Classification

Faults Detection and Isolation Based on PCA: an Industrial Reheating Furnace Case Study

Fault diagnosis in industrial processes using principal component analysis and hidden Markov model

Fault Isolation by Partial Dynamic Principal Component Analysis in Dynamic Process

Fault Detection with Improved Principal Component Pursuit Method

Fault Detection Behavior And Performance Analysis Of Principal Component Analysis Based Process Monitoring Methods

Kernel Generalization of Multi-Rate Probabilistic Principal Component Analysis for Fault Detection in Nonlinear Process

Fault detection method based on kernel principal angle

Simultaneous Fault Detection and Diagnosis Using Adaptive Principal Component Analysis and Multivariate Contribution Analysis

Improved PCA with Optimized Sensor Locations for Process Monitoring and Fault Diagnosis

Neural Component Analysis for Fault Detection

Primary-Auxiliary Statistical Local Kernel Principal Component Analysis and Its Application to Incipient Fault Detection of Nonlinear Industrial Processes

A Novel Dynamic Baysian Canonical Correlation Analysis Method for Fault Detection